Count down clock
 
Notifications
Clear all

Count down clock

29 Posts
8 Users
0 Reactions
12.6 K Views
Aurbo99
Posts: 2804
Moderator
Topic starter
(@aurbo99)
Member
Joined: 19 years ago

My bad..

I had 12 and 24 volts set up.. I labelled it as 5

I'm looking at keeping it 12VDC.

All the Q's do look backwards.. dont they..

Back to the drawing board..

Cheers


Reply
Aurbo99
Posts: 2804
Moderator
Topic starter
(@aurbo99)
Member
Joined: 19 years ago

go figure..

I posted versions 2 and 1 in that order..

I was supposed to post version 12 and 13..

Now how can I delete those to avoide more embarrassment. =P


Reply
Aurbo99
Posts: 2804
Moderator
Topic starter
(@aurbo99)
Member
Joined: 19 years ago

OK,

This was the last revision on the schem.. Hopefully it addresses the goof ups on the previous two images.

I'm beyond my comfort zone on this project so be gentle =P

But I've learned a hell of a lot so far.


Reply
Posts: 496
(@wombat)
Honorable Member
Joined: 19 years ago

Why did you use the transistors when you already have the driver chip as you are only drawing about 20ma from the LED's as they are in series just put them directly on the ULN 2003 chip and have common Annode going to the supply so you dont need the PNP transistors


Reply
Posts: 496
(@wombat)
Honorable Member
Joined: 19 years ago

you have the display as a common Annode so that wont work with the PNP transistors Has to be Common Cathode


Reply
pixeldigger
Posts: 144
(@pixeldigger)
Estimable Member
Joined: 19 years ago

Not wanting to hijack,

But I am making my own countdown board with coro, 50 light strings, SSRs and a NI-DIO-96, controlled by VB6.

Anyone interested when I finish ,Ill share the code.


Reply
Posts: 496
(@wombat)
Honorable Member
Joined: 19 years ago

another thing with your design is the DP output needs an NPN driver before the PNP transisitor otherwise you'll put 12V though the PIC chip

Smoke will escape!!!

Wombat


Reply
Posts: 854
(@terbobob)
Noble Member
Joined: 19 years ago
Reply
Posts: 854
(@terbobob)
Noble Member
Joined: 19 years ago

Dupicate post --- sorry


Reply
Posts: 496
(@wombat)
Honorable Member
Joined: 19 years ago

not much different design that one.. its mainly the output drivers that are wrong with this design how its hooked up to the PIC is not much different.

I would just use the same setup he has now and run it with resistors in each LED leg into the ULN 2803 chip. then use an extra NPN transistor on the Decimal Point 1K resistor to PIC

that will give up to 50mA drive to the LED's plenty for this design

Wombat


Reply
Page 2 / 3
Share: