Buffer/line driver ...
 
Notifications
Clear all

Buffer/line driver - null pixel without pixel

347 Posts
90 Users
0 Reactions
197.7 K Views
Posts: 10
(@competer)
Active Member
Joined: 10 years ago

Thanks Rob. It doesn't paint a clear picture on what needs to be done so I'll wait until they arrive and then ask questions from there. Appreciate your time.


Reply
RobG
Posts: 1255
 RobG
Topic starter
(@robg)
Noble Member
Joined: 14 years ago

To switch from 12V-24V to 5V:

1. remove existing solder bridge

b1

2. all 3 pads should be separate now

b2

3. solder bridge on the LV side

b3

BTW, you can use boards with default setting of 12V-24V in 5V environment, but you will not get the full 5V on the data output (it will work, just not as good.)


Reply
Posts: 10
(@competer)
Active Member
Joined: 10 years ago

Thanks Rob. 100% exactly what I needed to understand what I need to do the switch over. Many thanks.


Reply
Posts: 127
(@kreeve)
Estimable Member
Joined: 11 years ago

What distance from the controller does it make most sense to put these at? Last year I could get a little over 15' to my spiral trees before I had problems without these. Should I put them at about 10' or closer to controller?

Experience welcome?


Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

I put mine at 15'


Reply
Page 58 / 70
Share: