I need some help from the experts. I have 2 e682's running off of a trendnet switch hard wired to the lan port on my show PC. (Quad core Win 7) I have XL set up with the basic outlines of my house, (windows, door, eaves/gutters and vertical lines). e682's set up each using 7 universes of multicast (1-7 on one & 8-15 on the other). Each display item is wired to a separate output on the e682. Using 9 ports on each one. I have double checked my channel numbering in XL and feel that it flows correctly from model to model. My issue is that I am not getting any output on ports 8-9 on either one, and only about 1/4 of the channels on output 7. This is where we jump from Universe 2 to 3 on 1st controller, and 9 to 10 on the 2nd controller (first 2 universes on both work fine) I have checked the resistor packs, wiggled, jiggled, all the normal board stuff. If it was only one of the controllers exhibiting the issue, I would pull it back in to my shop and check it out. Since both are doing exactly the same thing, I don't suspect them. Where have I gone wrong on my setup?
rstehle wrote:I need some help from the experts. I have 2 e682's running off of a trendnet switch hard wired to the lan port on my show PC. (Quad core Win 7) I have XL set up with the basic outlines of my house, (windows, door, eaves/gutters and vertical lines). e682's set up each using 7 universes of multicast (1-7 on one & 8-15 on the other). Each display item is wired to a separate output on the e682. Using 9 ports on each one. I have double checked my channel numbering in XL and feel that it flows correctly from model to model. My issue is that I am not getting any output on ports 8-9 on either one, and only about 1/4 of the channels on output 7. This is where we jump from Universe 2 to 3 on 1st controller, and 9 to 10 on the 2nd controller (first 2 universes on both work fine) I have checked the resistor packs, wiggled, jiggled, all the normal board stuff. If it was only one of the controllers exhibiting the issue, I would pull it back in to my shop and check it out. Since both are doing exactly the same thing, I don't suspect them. Where have I gone wrong on my setup?
Post your e682 webpage and the xlights setup page
tucsonlights wrote:Post your e682 webpage and the xlights setup page
I've seen a lot of folks do that, but not sure how?
rstehle wrote:I've seen a lot of folks do that, but not sure how?
With windows 7, you can use the "snipping tool" program to capture the config screens and save them as image files. From there you can attach them into your posts
Wow, never realized how easy that was. Pics added to first post. Thanks!


