White arch
 
Notifications
Clear all

White arch

18 Posts
4 Users
0 Reactions
6,283 Views
Posts: 94
Topic starter
(@diyermaker)
Estimable Member
Joined: 6 years ago

Ok, thanks. I am trying anything I can find and the arrow-light was an option. Sorry for the dumb responses I am completely new to xLights and most pixel controllers.


Reply
Posts: 376
(@k-state-fan)
Reputable Member
Joined: 16 years ago

There are some great videos out there keith westely, virtual christmas summit, Canispater Christmas

Keith is doing his beginner class in the xLights zoom room tomorrow.


Reply
Posts: 68
 thg
(@thg)
Trusted Member
Joined: 17 years ago

Keith is doing his beginner class in the xLights zoom room tomorrow.

Where or what site does he announce this information from. I’m always late in hearing it. I do visit most of the Christmas forum daily or more. Just not looking in the right spot.

Thanks


Reply
Posts: 94
Topic starter
(@diyermaker)
Estimable Member
Joined: 6 years ago
K-State Fan wrote:There are some great videos out there keith westely, virtual christmas summit, Canispater Christmas

Keith is doing his beginner class in the xLights zoom room tomorrow.

Ok, I am young so I will see what my parents say...


Reply
Posts: 52
(@davwav02)
Trusted Member
Joined: 13 years ago
Diyermaker wrote:When I play a FSEQ file on FPP with just a arch it flashes the first bit of the sequence (less than a second) and all the LEDS turn on (white) then it kind of flickers until I unplug FPP. (New to xLights) Falcon Pi Cap

I have had a similar issue. It may be related to your pixels using too much power for the power supply they are connected to. I ran my entire display around 60% brightness for most of the season, since the lights are a bit blinding up close at night. On Christmas, during the day, I turned my display up to 100%. One row of arches 'froze' in all white. I reset the lights, turned down the brightness a bit, and everything was good after that. (They froze a couple more times in the process until I got down to about 85%)

To troubleshoot this, I'd start with the brightness turned down and gradually dial it up until you figure out how high it can go running your sequence.

Sent from my LM-G710 using Tapatalk


Reply
Page 3 / 4
Share: