Is there an easier way to make a strobe effect other then setting multiple "all on" and "all offs"? I need a very fast flash of a bunch of different models simultaneously.
Thanks
Use ON then change the end intensity to 0 or whatever you want and cycle count.
And if you plan on doing this in multiple sequences you could put them in a group to save some time
Sent from my iPhone using Tapatalk
There is an effect called Strobe. I take it you didn't like its output?
Gil, I tried the "strobe" effect, and was experiencing some latency in the lights. They did not all flash at the same time. I am trying to get a real strobe effect of about 8 - 10 cps. I tried resetting the parameters to 50% on and 100% off, but it did not correct it. So, I tried hard-coding the on's and off's to try to get a "clean" flash. Did not work either. Whats funny is that it shows the irregular flash in the previews.
Since my first post, I have been playing around with the system, and I might have a latency problem with my network and/or the E682. I haven't had a lot of time to pin it down though. I am going to try it on a dedicated computer to see if that helps.
David
Many have tried to do this with rgb lights. I think the few people who are happy with it have lower expectations. Most of use buy led strobes, which still are not as good. Then bite the bullet and buy curtain strobes with a xenon bulb. Depends upon how picky you are. Let us know what you end up doing.
I've always preferred using the Twinkle effect for strobing.
Skunberg wrote:Many have tried to do this with rgb lights. I think the few people who are happy with it have lower expectations. Most of use buy led strobes, which still are not as good. Then bite the bullet and buy curtain strobes with a xenon bulb. Depends upon how picky you are. Let us know what you end up doing.
Curious. Curtain strobe?
The strobes that screw into a c9 socket were developed for stage use and called curtain strobe. Which explains why we have some water issues with them.
Gilrock wrote:I've always preferred using the Twinkle effect for strobing.
That's what I am trying now.
Thanks
Skunberg wrote:The strobes that screw into a c9 socket were developed for stage use and called curtain strobe. Which explains why we have some water issues with them.
Oh, gotcha! I knew about those, just hadn't seen them referred to by the term curtain. Learned something new.
