singing face single...
 
Notifications
Clear all

singing face single channel re assignment

4 Posts
2 Users
0 Reactions
1,467 Views
Posts: 48
Topic starter
(@wilky37)
Trusted Member
Joined: 11 years ago
[#43205]

hi all been testing again today, this is my first year so have started out with singing christmas tree faces, i have 5 off 30 channel dmx dumb rgb controller boards, the problem is one of the channels is broken and is stuck on, as its too late to get a replacement board and i have a few spare channel outputs i want to know is it possible to re assign an element of a singing face a new channel number, i have tried to just highlight and change but it wont let me, any ideas or help greatly appreciated


3 Replies
Posts: 1015
(@gilrock)
Noble Member
Joined: 14 years ago

Can you show a screenshot of where its not changing for you? There are a few ways to define a singing face so I'm not sure where you're at.


Reply
Posts: 48
Topic starter
(@wilky37)
Trusted Member
Joined: 11 years ago
Screen Shot 2016 11 14 at 22.14.46
Screen Shot 2016 11 14 at 22.16.29

as i stated the second output on my controller is stuck on so i just want to resign the one channel, many thanks


Reply
Posts: 1015
(@gilrock)
Noble Member
Joined: 14 years ago

Ok that's easy. A custom model assigns channels by just adding the number you type into the cell to the start channel minus 1. So if you want to change output 4 just change all the 4's to be a different number. Like you could type in 75's in place of the 4's and then that section would be channel 825.


Reply
Share: