Should i trim contr...
 
Notifications
Clear all

Should i trim controller channels?

11 Posts
4 Users
0 Reactions
3,084 Views
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago
MrDudeMan wrote:PDU is the universe data that is sent over the network. One PDU per universe.
If you have unused channels in the middle of used channels on the same universe you are sending them as blank channel data as well.

Sorry. My networking background filtering through.

PDU = Protocol Data Unit.

E1.31 sends one universe time slice (aka frame) in a single PDU. If you have ten universes defined, it takes ten PDUs to send one time period's worth of data. At 40 frames per second for ten universes, you send 40 * 10 PDUs each second. In my show I have 150 universes. If I start to waste space in a PDU then I end up adding a lot of traffic.

All switches, routers and WiFi APs have a pps (Packet per second = PDU per second) rating. That along with the number of bytes in the PDUs controls the actual throughput of the network.

For example, if I have a device with a 1000 pps rating if I put 10 bytes of useful data in the PDUs then I have a network with an effective carrying capacity of 10,000 bytes per second. If I put 1000 bytes in each PDU, then I get a network with 1,000,000 Bytes per second carrying capacity. If you look at E1.31, it tops out at 512 bytes per PDU. As a protocol E1.31 hobbles the network to half of its potential capacity. DDP is much better because it stuffs the PDUs as full as possible (1200 byte payloads and ignoring jumbo frames) making the network usage as efficient as possible.

For the network purists, I have intentionally left out interframe gap, header overhead, VLAN headers, checksums and a host of other factors that really should be in an accurate description of network overhead.


Reply
Posts: 34
Topic starter
(@fabiousa7)
Eminent Member
Joined: 11 years ago
MartinMueller2003 wrote:Every Ethernet packet has overhead needed to route the packet through the network. More packets with less data means more network processing for less useful data transferred through the network. E1.31 packets packed full means fewer packets transferred through the network which means the network does not have to work as hard to transfer the same amount of data. I do use some E1.31 in my show and the E1.31 packets are as full as possible (512 bytes each) and only the last universe is partially filled. I do NOT associate a universe to an output port on a controller. I associate a set of universes to a contrlloer and then have the controller partition the data to the ports.

This was helpful.
Just to validate my understanding.
I have a new powerbox/controller i'll be using for my new arches 5x150pixel each, so following your recommendation i have each universe with 512 channels and then broke down the only used ports from the bottom up using every available channel.

Is this correct?

Capture

Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Yes, that is the way I would configure it.


Reply
Posts: 34
Topic starter
(@fabiousa7)
Eminent Member
Joined: 11 years ago

Last question (on this topic)

Is it okay to leave the other universes assigned to this controller or should i zero them out until i need them?
(i plan to use this controller for mini-trees next year)

Capture2

Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

you can configure anything you want on the controller. Just dont activate the extra universes on the show player.


Reply
Page 2 / 3
Share: