I have an E1.31 DMX bridge.
Output 1 is connected to a 36 channel DMX board and configured as universe 1 with 36 channels
Output 3, 4, 5, & 6 are configured as universe 2, 3, 4, & 5 respectively, each with 16 channels
I am setting up a configuration in XLights.
Instead of adding 1 controller with 5 universes of 26 channels, I added 5 DMX controllers as follows:
DMX controller for universe 1 with a unicast IP address of 192.168.2.210 and set the channel count to 36.
DMX controller for universe 2 with a unicast IP address of 192.168.2.210 and set the channel count to 16.
DMX controller for universe 3 with a unicast IP address of 192.168.2.210 and set the channel count to 16.
DMX controller for universe 4 with a unicast IP address of 192.168.2.210 and set the channel count to 16.
DMX controller for universe 4 with a unicast IP address of 192.168.2.210 and set the channel count to 16.
I haven't tested yet but is there a problem with defining multiple single universe controllers this way or should I configure a single multi-universe controller? I don't think there is a problem but thought I'd ask before I got to far down the path.
thanks
It will be fine.
As Keith said above, it will work just fine.
As said above will work fine, I have a bridge setup similar to what you are describing and works fine.
