3-D Layout?
 
Notifications
Clear all

3-D Layout?

11 Posts
4 Users
0 Reactions
4,752 Views
Posts: 1763
Topic starter
(@santacarl)
Noble Member
Joined: 19 years ago
[#56646]

Hey All,

When I check the 3-D box in my layout tab to get that view all my models are offset WAY to the upper right corner...Nothing matches my 2-D layout. Up until now I haven't really needed a 3-D look but I was playing with some new props that might be better viewed in a 3-D layout but I'm obviously missing something.

I can't find any way to correct this.

Anyone have an idea what controls this or know of a video that might help show where I took a wrong turn?


10 Replies
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago

Don't have an exact answer, but I remember something about "X0=Center" checked on or off.
But, before you take my advice, after many attempts to use "3D", I scrapped the idea. 2D has worked just fine for what I'm doing.


Reply
Posts: 1763
Topic starter
(@santacarl)
Noble Member
Joined: 19 years ago
algerdes wrote:Don't have an exact answer, but I remember something about "X0=Center" checked on or off.
But, before you take my advice, after many attempts to use "3D", I scrapped the idea. 2D has worked just fine for what I'm doing.

Thanks Mike... Yeah I tried that "XO=Center" toggle and it went from bad to worse....Haha...:blink:

I'm starting to think I just need to stick with 2D too and take my best guess at getting the depth perspective that I was hoping to use close enough to make it usable.


Reply
Posts: 1763
Topic starter
(@santacarl)
Noble Member
Joined: 19 years ago
MikeKrebs wrote:Like most 3d programs, you will need to use x, y, and z. Z being the depth. On my layout, I would push most of items negative to move them into position. I had real trouble moving them in the preview. It was pretty easy to put in absolute values to move them.

I bet once you figure out the magic, it would be pretty easy to move them in the Z direction in the preview. But just playing around, I couldn't figure out the magic.

Is there a toggle some place to show the x, y, and z? I was playing with it earlier now I don't see it.... I've played with this so much I can't remember where it was.....Haha


Reply
Posts: 1763
Topic starter
(@santacarl)
Noble Member
Joined: 19 years ago
MikeKrebs wrote: https://m.youtube.com/watch?v=-5yuxsnvJeU
The secret sauce revealed...skip to about 4 minutes for how to move items. The key for me is to find the blue arrow.

Size /location shows the x,y,z

Thanks for the link Mike...

Whoa Buddy....that's like drinking out of a fire hose! Haha...:biggrin2:

I'm seeing a serious time investment there. Sounds like it might be above my 'paygrade'....:unsure:

As to "Size/location shows the x,y,z".....I no longer see "Size/location"....I must have inadvertently clicked something to make it go away....

Well....DOAH....I found it.... Didn't have a model selected.....:zipped:


Reply
Page 1 / 3
Share: