My Micro Trees
 
Notifications
Clear all

My Micro Trees

43 Posts
22 Users
0 Reactions
22.5 K Views
Posts: 255
(@celtman123)
Reputable Member
Joined: 13 years ago

Just a whisk and a toilet plunger...

Sent from my iPhone using Tapatalk


Reply
Posts: 2229
(@plasmadrive)
Famed Member
Joined: 15 years ago

Great job... how tall are they?


Reply
derekbackus
Posts: 565
Topic starter
(@derekbackus)
Honorable Member
Joined: 15 years ago
plasmadrive wrote:Great job... how tall are they?

Thanks. About 13.5". Each leaf is 14", but at the angle shrinks a little.

dmcole wrote:Two thoughts:

  • The same concept would work with Coroplast, no?

Don't know. I would think Coroplast is too thick to push the 12mm pixels through. Certainly you could bend Coroplast up that way and mount the pixels on the outside. I've never worked with Coroplast so I'm not entirely sure what is and is not possible.

dmcole wrote:Two thoughts:

    • No offense, but I immediately thought of a Dalek when I saw it. "Exterminate!" Not very Christmasy, sorry.

    Awesome. I wish I could say that's what I was going for, but I've never seen a Dalek before I this pic.


    Reply
    james70818
    Posts: 2045
    (@james70818)
    Noble Member
    Joined: 19 years ago
    dmcole wrote:Two thoughts:

    • The same concept would work with Coroplast, no?

    \dmc

    You could do this with coro. I can set the machine to only cut the first layer. Similar to the way a coroclaw cuts only one layer. Just not limited to being in a groove like the claw. Also since I use a 1/8" bit you can keep the seam on the inside and the exterior stays smooth. I'll mock one up this weekend.

    James


    Reply
    Posts: 928
    (@arw01)
    Noble Member
    Joined: 13 years ago

    Be interested in that James too, would you be able to produce them to sell?


    Reply
    Page 2 / 9
    Share: