I still had some original Ray's pixels from last year (the silicone bullet tapes without any epoxy), which I've sealed using 2 coats of Plastidip.
It was a total failure - I had 54 strands up on a megatree, which once it started raining the first strand failed within 3 minutes.
15 minutes after that I had 10 strands fail. Overnight and that count was up to 41 failed. The rain was so light you can work in it for an hour and not really get wet, but it was wet enough to take out the strands.
No more Plastidip (and no more Rays of course). I've noticed I can fairly easily salvage the strands by taking a blow dryer to it, so I pulled off all the strands to dry.
I think I'm going to try and use liquid tape to try and seal them. LUCKILY I've used the James7818 mounting strips for these which means I can work on the backs without taking them off the bands first.
Does anybody have any experience with how to make putting on liquid tape easily? I know I can get the tape from Home Depot, but where do I get the syringe and injector tip for it?
How much of it do I need? I'm only planning to put back up 27 strands (1350 lights).
I have used it a couple of times but have had trouble getting it to "dry" properly. I say dry, but it never really dries.
Instead I have heavily invested in Corrosion X (the squirt bottle) not the aerosol can. Any time I have lights on the fritz I coat the entire back where the wires enter with it and it wicks away the water very quickly.
Sent from my iPhone using Tapatalk
Did you thin the plastidip with naptha.
tucsonlights wrote:Did you thin the plastidip with naptha.
Yes. I couldn't find the plastidip thinner, so I used naptha. Was that bad?
