I see a lot of posts here and elsewhere covering temporary megatrees - portable holes, ASAP designs, etc.
I have an existing 20-foot flagpole, but I don't think it's strong enough to handle being a megatree, at least not without a lot of guy wires. What I would prefer to do is replace it with a permanent post that could be a flagpole for most of the year and turn into the megatree for the holidays, preferably strong enough to not need guy wires.
Is there a cost-effective way to do this? I've done some searching to see if it's possible to get, say, a 25 foot length of schedule 40 galvanized steel pipe, but no luck. Am also considering a telephone pole - a nice benefit would be that it's climbable, but not sure if it would be permitted as a flagpole in my area (no HOA, but in an urbanized county.)
Are you looking at a 360 degree Mega tree design? Are you considering climbing/laddering the pole to attach your lights/flag? What is the overall height you want when you are done? 25'?
Probably a 180. Was thinking about putting a permanent metal ring around the bottom (which means I get to learn to weld!) so could use that to guy the backside for balance and just mulch/landscape the circle instead of having to worry about mowing it. Probably around 25' tall.
If I get a metal pole that will do the job I will just make sure I can raise/lower the top mount, same as an ASAP design. If I were to go with a wood utility pole I would probably install pegs and use a harness and sling to climb.
Based on the telephone/power poles used around my area, I would think that would be pretty sturdy. And it sounds like you are willing to climb your pole as needed. My guess is most of us that have Mega trees in our displays like to use something like an "ASAP" setup and "Portable Holes" so we don't have to climb and we can move the Mega tree as needed. (A few of us probably don't bounce so well if we fall from 25'.) You don't mention what type of wind speeds that you expect to see in your area.
I chose to use schedule 80 aluminum pipe (purchased locally) to make my 30’ ASAP pole setup. (see http://doityourselfchristmas.com/forums/showthread.php?55837-New-guy-the-story-so-far-and-considerations-for-next-year&p=533992#post533992 ). I’ve been happy with this set up. The hinged base allows me to raise and lower the pole by myself. My Mega tree is a 180 degree design so I do use one cable attached at the top to counterbalance the pull of 32 strings of lights during show season. If I were to then use it as a flag pole after show season, I‘m confident that the pole would be just fine without the single guy wire based on the structural design of the hinge and pipe socket. You mentioned learning to weld (sounds like some of my welding I’ve done in the past) but I had welding friends help me design and weld up the hinge plate/pipe socket for the base. I didn’t want something with that much potential stress to depend on my welding. LOL! I would have paid a welder just to make sure it was going to hold up to what I was requiring of the design.
This year I will be putting a second 3' piece of PVC pipe in the ground and using my 30' ASAP in a different location as a flag pole during the Christmas light off season. I will be able to remove my hinged based from the Mega tree location and insert the base into a new flag pole location.
Hope this helps.
