Ok so First question on the forum and its kind of an extreme one I think. Any and all help would be greatly appreciated! I have a 40ft tall panel tree that im wanting to turn into a pixel tree instead of the foliage. I plan on getting the pixels from ray wu store. Roughly 25,000 pixels for this 360 degree tree. Im starting off new to the pixel stuff and have no clue what the best software/hardware situation is. I currently use lor for the show idk if I can integrate this into the pixels as well....help...thanks again
falcon controller for to control your pixels, raspberry pi running fpp to run your show, and xlights to create your show and a whole lot of patience. it will take alot of work to get to a spectacular outcome. i know a little bit about a little bit but not nearly enough to get you to the end. i am sure there will be someone here that would love the challenge to get you there. good luck.
vegaschristmas wrote:Ok so First question on the forum and its kind of an extreme one I think. Any and all help would be greatly appreciated! I have a 40ft tall panel tree that im wanting to turn into a pixel tree instead of the foliage. I plan on getting the pixels from ray wu store. Roughly 25,000 pixels for this 360 degree tree. Im starting off new to the pixel stuff and have no clue what the best software/hardware situation is. I currently use lor for the show idk if I can integrate this into the pixels as well....help...thanks again
Wow, your first post and you ask the loaded question about Best Hardware and Software. 🙂 That question is one that can start flame threads, so just to head that off at the pass, here's a great comparison matrix of all 16 port controllers (and some that allow more than 16 ports)
http://nutcracker123.com/nutcracker/rgb_controllers/
As far as Sequencers, there are lots of great ones that are Open Source. In alphabetical order of ones that I have seen referenced on the forum:
HLS
Nutcracker (incorporated into XLights I believe)
Vixen
XLights
There are pros and cons for each and workflow can be a little different between them. Everyone has a preference, but what I would recommend is to try them and see which one you like best, which one fits your work flow and how you want to sequence, they're all free thanks to the hard work and sacrifice of many people.
Personally I use 2 different sequencers, depending on what I am trying to accomplish, but you really need to try them to decide for yourself.
Also, for scheduling, a lot of the sequencers have scheduling included but the consensus seems to be FPPfor scheduling and playback.
My opinion is falcon, xlights, and FPP. There have been many debates on the best controllers and the majority agree on falcon. Debates on software are a little different. But, since the ones already mentioned are free, try them all and decide for yourself.
James
Sent from my Pixel using Tapatalk
