My Mega Tree idea (...
 
Notifications
Clear all

My Mega Tree idea (possible implementation)

5 Posts
4 Users
0 Reactions
2,559 Views
ChristmasBuddy
Posts: 452
Topic starter
(@christmasbuddy)
Honorable Member
Joined: 14 years ago
[#40712]

Looking for some feedback on this for planning purposes.

This image is one of two Holly Trees that I have at the end of my driveway. It's a half circle so a tree is at each entrance and it is practically at the street.

Holly Tree

For years I have place icans in the trees as best as I can but it looks sucky imho so I am wanting to do something different.

My initial thought is to make my own net so that it wraps the tree branchs in a uniform way. Then tie the lights to the net. Yes, it will have some weight to it. For durability I was thinking para-cord for the net.

My goal is something like this.

Holly Tree goal

Here's my delima. I will need a strong topper to attache the net to but it needs to not bend the top of the tree over due to the trunk up there is not that stiff.

Since it is so close to the street I do not plan on using it for the flashy mega trees that I have seen. I just don't want to detract from show that is closer to the house.

Any ideas or suggestions?

Thanks!

Buddy


4 Replies
Posts: 4092
(@skunberg)
Famed Member
Joined: 18 years ago

I saw someone use plastic chicken wire fence. Trim the tree, cover with fence, attach lights. Lots of zip ties.


Reply
ChristmasBuddy
Posts: 452
Topic starter
(@christmasbuddy)
Honorable Member
Joined: 14 years ago

Yeah, I thought about that too. I even attempted a slimmed down version using actual wire chicken fence I had. I did not like the look. I did look at the plastic type and I did not like it. HOWEVER, it was more pliable than the wire fencing.

After dabbling a bit today I came up with this for the netting part.

netting v01

I'm thinking maybe a rebarbed circle with a support piece that would slide into a pipe that would extend down the trunk in a secure way. If I can design it right the support pipe could sit on lower branches for added weight distribution.

Buddy


Reply
Posts: 24
(@kcoggin)
Eminent Member
Joined: 17 years ago

Following

Sent from my SM-G900P using Tapatalk


Reply
Posts: 1159
(@deonb)
Noble Member
Joined: 13 years ago

How about Christmas Ducktape (aka PVC pipes).

Create an inner ring with 8x 45degree connectors, 4x T-connectors and some Schedule 40, and an outer ring made the same but with a larger diameter, with supports running from the inner ring to the outer ring.

Something like this:

PVC Ring

If it's not sturdy enough you can use 8 T's and supports instead of 4.


Reply
Share: