Mega Tree Mast -- R...
 
Notifications
Clear all

Mega Tree Mast -- RFC

7 Posts
3 Users
0 Reactions
4,616 Views
Posts: 406
Topic starter
(@jboyles7)
Honorable Member
Joined: 17 years ago
[#12481]

My Megatree mast is 2" PVC, which covers a 1 1/2" PVC pipe that is sunk in the ground 2 ft -- leaving 8' above ground.

The 2" pipe is going to be 2 sections: a 10' section coupled together with a 5' section the two sections are bound using a coupler. All of the 2" PVC is above ground.

If I PVC cement the 2 sections together (5' + 10'), it will not fit that well in the garage post season. Has anyone dry fit 2 sections like this and how'd it work?

There will be 3 guy wires, but the top of the tree has a 7 lb 3D star too. . .

I'm a little concerned. . .

All input welcome!


6 Replies
Posts: 98
(@hartlove)
Estimable Member
Joined: 17 years ago

I haven't tried this myself, but...

What if you run a 3/8" bolt or 2 above and below the joint, after you have it all put together. That would tie both pieces of 2" to the 1.5" pipe.


Reply
kychristmas
Posts: 3955
(@kychristmas)
Famed Member
Joined: 18 years ago

That is almost exactly my setup. Except I am using an 8ft piece of Fence Top Rail driven into the groune about 3 feet. Slip the 2 Inch PVC over the Top Rail. My top is only 3 or 4 ft.

I attache the Guy wires at the coupling holding the two sections together. They are dry fit so I can take them a part. In fact, the entire thing breaks down so I can store it away easily.

Here are some pictures: http://www.kentucky-christmas.com/Projects/tabid/357/AlbumID/896-41/Default.aspx


Reply
Posts: 406
Topic starter
(@jboyles7)
Honorable Member
Joined: 17 years ago

Ironicly, I bought the bolts today to tie them together, but didn't think of putting one above and one below. I was just thinking of keeping it from spinning. That's an excellent idea!!

Thanks!


Reply
Posts: 406
Topic starter
(@jboyles7)
Honorable Member
Joined: 17 years ago

Your's look sturdy.

Do you think the 1 1/2" PVC covered by the 2" is sturdy enough? Or should I go get a fence post?


Reply
kychristmas
Posts: 3955
(@kychristmas)
Famed Member
Joined: 18 years ago
jboyles7 wrote:Your's look sturdy.

Do you think the 1 1/2" PVC covered by the 2" is sturdy enough? Or should I go get a fence post?

Mine is Fence Top-Rail, not post. Its much easier to cut and deal with. Since ground post really only keeps the mast from shifting. I wou think it would work. It's possible that it keeps the mast from flexing too much. Clearly, most of the support comes from the guy wires.

The metal is easier to drive into the ground. Last year the ground was soft, this year its been very dry so I'm thining its going to be hard to get my stuff in the ground.


Reply
Posts: 406
Topic starter
(@jboyles7)
Honorable Member
Joined: 17 years ago

I put a cut 2" PVC pipe into the ground with a cap. Pull the cap off and put the 1 1/2" 10' PVC pipe into it. 🙂

I like your fence rail alot though. Humm -- what to do . . .


Reply
Share: