Mega Tree Guy Wires
 
Notifications
Clear all

Mega Tree Guy Wires

13 Posts
6 Users
0 Reactions
13.6 K Views
rlilly
Posts: 993
Topic starter
(@rlilly)
Noble Member
Joined: 19 years ago
[#3758]

I was reading the Megatree construction detailsat Nevada Christmas and got to thinking that more thought needed to be put into the guy wire selection.

After doing a bit of research on wind loading and wire rope, I came up with the attached guy wire calculator.

In the Carson Valley, the wind can really blow and the 70 MPH gusts that Wayne describes in his write up are not uncommon. He opted to go 'one size up' from the 1/8" and described that as overkill. Using the calculator, turns out it's not overkill at all, and in fact may be undersized.

To use the calculator, you enter the data for your set up/location highlighted in red.
The blue values are the appropriate guy wire sizes.

Edit: Updated sheet to reflect Deplanche's comments #1 & 2 below.


12 Replies
rstehle
Posts: 4348
(@rstehle)
Illustrious Member
Joined: 19 years ago

Great job, very helpful!
Thanks!


Reply
Posts: 121
(@vairmoose)
Estimable Member
Joined: 19 years ago

Not to criticize the table, it provides much food for thought, but i don't see where it allows for various configurations - i.e. 3 wire, 4 wire, 5 wire, etc. The 3 wire would generate the highest per wire loading, whereas the 5+ wire arrangement reduces the per wire loading and provides some measure of redundancy. 4 wire would reduce the per wire loading but not provide any real redundancy.

Larry


Reply
Wayne J
Posts: 7789
(@wayne-j)
Illustrious Member
Joined: 20 years ago

Don't forget the use of dual guy wire setups..... I use a set at top and midway up the mast. I use 1/16" wire cable, and I really think I could climb up the thing. LOL


Reply
Posts: 1084
 ben
(@ben)
Noble Member
Joined: 19 years ago
Wayne J wrote:Don't forget the use of dual guy wire setups..... I use a set at top and midway up the mast. I use 1/16" wire cable, and I really think I could climb up the thing. LOL

That is what I am going to use with 3/32" steel braided cable. 3 in the middle and 3 at the top coming to a single ancor point on the ground.

Ben


Reply
Page 1 / 3
Share: