I used a similar flag pole from harbor freight this year. I made a 1/8 aluminum circle piece for the top with a hole in the center and 16 hole over the 180 degree front. I unscrewed the gold ball at the top and used a bolt to attach the aluminum circle. I added pixel strips 16X50 and used bungee balls at the bottom. telescope the flag pole up until strips were straight. used a couple of guide wires and it worked out great. we do not get snow here, but it did survive a few good rain storms.
I have a pole from Menards and have been hanging 14 - 50 count C7 LED strings from it for the past few years. Probably a lot less weight than pixels.
For my topper I cut out a circular piece of plywood, then cut a hole in it for the pole. I picked up some machine threaded hooks that I bolted on.
To keep it from sliding I picked up a rubber pipe coupler from the plumbing section. Basically a rubber sleeve that I tighten with a pipe clamp. The plywood then sits on top of that.
Not the most elegant solution but works for my tree. I plan to build a Pixel tree for 2019 but will likely build a pole for it as I will probably keep the existing “dumb” tree.
Sent from my iPhone using Tapatalk
I use a 25ft telescoping flag pole for a small mega tree (15ft). I use a pvc end cap with hooks screwed directly into the pvc. The end cap is slightly larger than the pole so I used foam weather stripping to give it a slightly tighter fit and that with the weight of the lights keep it in place very well, however a simple eye bolt could be screwed in and used as a tension bolt if I felt I needed it. I run my lights up and over the hooks and use tent stakes to stake the light strands directly to the ground. I use led light strands, not pixels so not sure if what I do would work or not for you. (I'm a newbie, only 2 years in on a limited budget, one day would like a pixel tree.)
DENNISMZ wrote:I’m thinking of doing a mega tree this year, does anyone know of a commercially available top ring that will either slide down or clamp around an existing flagpole. I think the diameter where I need to put it is either 1.75” inches or 2.14 inches depending on how high I go.Thanks
Dennis
I used a 5" pipe threaded to a floor flange and screwed to an old 9" frying pan for my mega tree.
See link for a 2-1/2" floor flange : https://www.plumbingsupplynow.com/2-1-2-black-iron-floor-flange
Frying pan : https://www.ikea.com/us/en/p/kavalkad-frying-pan-black-00267706/
Another option is a chain link fence Post Pipe Floor Flange: https://www.ebay.com/itm/173241488416
