Look at this document. This is the Portable Hole II which is more robust than the PH Lite. Specifically see the photo on page 3 for receiver assembly.
http://www.magicchristmas.org/portable-hole.html
I tried to attach the file, but it keeps failing.
Yes that's the instructions I have as well. I think I have what matches this. Just checking before pouring concrete.
Sent from my iPhone using Tapatalk
I think the only thing I would do on the portable hole in set a pin in the top threads. Nothing over the top but a single 1/4" rod or bolt about 6" long would keep it from spinning. This would be drilled through the nipple and coupling threads locking them in place.
I am not faulting the design by any means this is just what I would do to avoid the coupling spinning. The biggest reason I would be using electrical couplings which are smooth.
FBiff wrote:I think the only thing I would do on the portable hole in set a pin in the top threads. Nothing over the top but a single 1/4" rod or bolt about 6" long would keep it from spinning. This would be drilled through the nipple and coupling threads locking them in place.
I am not faulting the design by any means this is just what I would do to avoid the coupling spinning. The biggest reason I would be using electrical couplings which are smooth.
If you use the recommended coupling I doubt you would have a problem with spinning. My original portable hole has been in use for 4 yrs and sits outside year round. I originally used a 7ft pc of 2" pipe for my lower pole and now I want to get it out and put in a 10ft piece. I have been soaking my the joint in penetrant for several days and banging on a pipe wrench on the pole with a sledge hammer and I still have not been able to budge the thing loose. The concrete has not even cracked as I have been banging the pole trying to get it to move.
Hoping to pour the concrete for a new (2nd) pole this weekend. Just have to get the bottom board of the form cut and the center pieces and rebar tied in. Should have good weather the next 4 days. Looks like I may have to make another PH if cannot succeed in getting the short pole out or just keep using my original 2 stage JUMP pole. The JUMP has been one of the best things I ever built for my show. Before the JUMP I had several poles get blown over and / or bent even with anchor wires to the top and mid points.
Has anyone used the orange corkscrew/auger type anchors (like the ones at HD) instead of 3' long rebar? I have many anchors I have used the last couple of years with guy wire-setup megatrees. Since I have them, would like to use them if possible/reasonable. Wanted to see anyone had ever tried this or not---especially if anyone has a "hard lesson learned" with these anchors and the PH/JUMP/ASAP poles. Many thanks in advance.
