For the past several years, we have had a 36 foot tree based on a radio tower. 16 wire rope based strings connected to a solid top directly connected to the center pole of the radio tower. With a lot of manpower, we have swung the tower with the lights attached up into place. It worked, but has been a pain getting enough muscle to put it up in October, and back down in January. Also, if anything needed maintenance, we were out of luck.
This year we want to double the number of strings. That will be 32 strings of 100 pixels each. (All pixels zip tied to wire rope, taking the stress off of the pixels, and providing for a view from 360 degrees.)
What we want to do is have a way to pull the lights up the tower, once the tower is upright and properly guyed down. Many different ideas have come and gone, but none has been proved "doable".
Does anyone have a standard pole going up 35 feet, with a winch system to pull the lights up? Do you have pictures? Do you have any 'words of wisdom' as to what to and what not to do?
Thanks in Advance for anything that you may be able to send our way.
Al & Peg
I was just on Matt Johnsons site and he has a large mega-tree not sure how but says they can be lowered https://livinglightshows.com/rgb-pixel-megatree-kit/
How wide is your tower? You could make a collar that rides up the outside tide to a set of cables going to the ground on the inside. This means you would have to stop a few inches from the top to leave room for some pulley's. It also means you can use an electric winch at the bottom, making raising and lowering simpler.
Look up “crazychristmascrew” on YouTube.
He did something close to what your asking. He used the radio tower added rings for support and pulled them up with a winch or rope( I forget which one )
Thanks folks. I'll give them all a try.
BTW - I found CrazyChristmasCrew on YouTube, but haven't found where he shows his mega tree yet. But I'm still looking! 🙂
