LEDTRIKS Debugging ...
 
Notifications
Clear all

LEDTRIKS Debugging Problem

22 Posts
7 Users
0 Reactions
10.6 K Views
Macrosill
Posts: 9739
(@macrosill)
Member
Joined: 19 years ago

It appears as though this problem has been remedied. The leds were installed backwards. Let this be a lesson to all, pay close attention to every detail when building a project. You may miss a minute detail that will require the re soldering of over 1500 joints.


Reply
Posts: 353
(@stempile)
Reputable Member
Joined: 19 years ago

Test before you build, test during your build and test after

Before I started on the big board panel (build 2 of 3 right now), I built a small 4x8 LED matrix on a solder pad proto board. I posted questions to the board about its performance. It used of 32 LEDs and one $1 proto-board, the only real expense was the couple hours it took to make it.

I wanted to make sure the driver boards all worked before spending the time to build the big board. Testing is a good thing that takes time up-front but will save lots of time in the end.

We have all made mistakes and it hurts but you learn from them. Test before your build, test while you build and test test test a lot after you build!

Example Picture
ms


Reply
Posts: 49
Topic starter
(@dvanteslaar)
Trusted Member
Joined: 19 years ago

Re: Test before you build, test during your build and test a

stempile wrote:Before I started on the big board panel (build 2 of 3 right now), I built a small 4x8 LED matrix on a solder pad proto board. I posted questions to the board about its performance. It used of 32 LEDs and one $1 proto-board, the only real expense was the couple hours it took to make it.

I wanted to make sure the driver boards all worked before spending the time to build the big board. Testing is a good thing that takes time up-front but will save lots of time in the end.

We have all made mistakes and it hurts but you learn from them. Test before your build, test while you build and test test test a lot after you build!

Example Picture
ms

Matt,

I went to your project webpage and viewed it (or was it a posted thread in the forum - I can't remember) a short time ago; good advice to follow. My mistake was a very easy one to avoid had I read the instructions carefully (and making a smaller prototype is an excellent idea as well) - rookie move on my part!

David


Reply
Posts: 49
Topic starter
(@dvanteslaar)
Trusted Member
Joined: 19 years ago
Macrosill wrote:It appears as though this problem has been remedied. The leds were installed backwards. Let this be a lesson to all, pay close attention to every detail when building a project. You may miss a minute detail that will require the re soldering of over 1500 joints.

Words to live buy, Brian! Anyone who reviews these posts should yield to the advice within them; mine is a relatively easy mistake to address, but one hell of a time consuming job to correct!

David


Reply
Jeff Millard
Posts: 1450
(@jeff-millard)
Noble Member
Joined: 19 years ago

Man Oh Man! Every one backwards! Oh my gosh... I wouldn't wish that on my worst enemy. I just cringe at the thought of having to re-do all that soldering. What a drag!

Jeff


Reply
Page 4 / 5
Share: