LEDTRIKS Debugging ...
 
Notifications
Clear all

LEDTRIKS Debugging Problem

22 Posts
7 Users
0 Reactions
10.6 K Views
Posts: 49
Topic starter
(@dvanteslaar)
Trusted Member
Joined: 19 years ago
[#478]

I have completed the LEDTRIKS contoller, Panel and Interface Cable assembly (SEE BELOW). For some reason, I am getting NOTHING out on the LEDTRIKS panel when I run a test sequence in Vixen.

I have checked all the connections and everything is intact. I have grounded the controlling board to pin 18 of the DB25 (as I have an external power supply that has a rated output of 5V 4A SEE BELOW). I have approx. 5.2 volts reading on pin 1 of the chips.

I have read through every post on this site, as well as the LEDTRIKS archive site and have found nothing useful for my specific problem. Any suggestions on a debugging procedure to find out what's going on would be appreciated.

David


21 Replies
Posts: 1062
 Ronp
(@ronp)
Noble Member
Joined: 19 years ago

Are you enabling the vixen output. each time you open a sequence.

If you see the previewer running the output is not enabled.

(Also play is the second button The play from here is first)

On the controller you should have a shunt in pin 1 of the board select.

Plugin setup? no changes should be made to the chanel # just make sure you are on the correct port
http://www.putfile.com/pic.php?img=6404400


Reply
Posts: 49
Topic starter
(@dvanteslaar)
Trusted Member
Joined: 19 years ago
Ronp wrote:Are you enabling the vixen output. each time you open a sequence.
If you see the previewer running the output is not enabled.

Plugin setup? no changes should be made to the chanel # just make sure you are on the correct port
http://www.putfile.com/pic.php?img=6404400

OK, when I load a LEDTRIKS sequence, and I change the playback mode from "preview" to "execute", nothing happens. The Playback controls at the top dont seem to function. How do you actually run a sequence to the board?

Also, under LedTriks > Attached Plugins. I enabled the LedTriks Plugin and is displays, under PORT CONFIGURATIONS, "378 Ledtriks". To the very top-right, there is a CHANNELS title ... do I need to do anything with this? Right now, its greyed out.


Reply
Posts: 1062
 Ronp
(@ronp)
Noble Member
Joined: 19 years ago

once you click play you will not see the sequence run on vixen just on the pannel

http://www.putfile.com/pic.php?img=6404477

Also the task maniger should show Vixen using 99 % when running a sequence


Reply
Posts: 49
Topic starter
(@dvanteslaar)
Trusted Member
Joined: 19 years ago
Ronp wrote:once you click play you will not see the sequence run on vixen just on the pannel

When I click play (the second button), nothing happens on the board.

Attached is a picture of my shunt on pin 1 ... is this setup correct?

Also, how do I determine the correct port number? The standard choices under the Ledtriks Plugin for the Parallel Port setup are: STANDARD PORT 1 (0378), STANDARD PORT 2 (0278), and STANDARD PORT 3 (03bc) ... I am using the first setting (although I have tried all three with no results).

When I put a check box in the LedTriks Plugin, the CHANNELS option to the right are pre-filled in with '1 TO 0".

When I press play, the taskmanger IS SHOWING 99%


Reply
Page 1 / 5
Share: