Led Spacing
 
Notifications
Clear all

Led Spacing

16 Posts
9 Users
0 Reactions
11.3 K Views
Posts: 16
Topic starter
(@donross)
Eminent Member
Joined: 19 years ago
[#127]

What is the optimun spacing for the leds?

Thanks,
DocTanner


15 Replies
wjohn
Posts: 1102
(@wjohn)
Noble Member
Joined: 20 years ago

Depends on the distance to the viewer. I'll let the experienced Panel Builders comment, but 1/2 or 1 inch seems to be common.

I am going with 15mm (25.4mm to the inch), so that the panel fits in nicely on the front of the house.

John.


Reply
Posts: 101
 Zane
(@zane)
Estimable Member
Joined: 19 years ago

We user a simple half sheet of Peg board and it works fine. We can read the sign, at night, from 2 ft away to over a block away.


Reply
wjohn
Posts: 1102
(@wjohn)
Noble Member
Joined: 20 years ago
Zane wrote:We user a simple half sheet of Peg board and it works fine. We can read the sign, at night, from 2 ft away to over a block away.

Zane,

is that 25.4mm pegboard or that other type - the 1 inch pegboard..


Reply
Posts: 101
 Zane
(@zane)
Estimable Member
Joined: 19 years ago

Yes it is the 1 inch peg board.


Reply
Jeff Millard
Posts: 1450
(@jeff-millard)
Noble Member
Joined: 20 years ago
wjohn wrote:
is that 25.4mm pegboard or that other type - the 1 inch pegboard..

😆 😆 😆 😆 😆

I wish I could draw the little smily guy on his head so you didn't have to look at him upside down John...
jeff


Reply
Posts: 16
Topic starter
(@donross)
Eminent Member
Joined: 19 years ago

Anyone have a good source for the led holders?

Thanks, DocTanner


Reply
Macrosill
Posts: 9740
(@macrosill)
Member
Joined: 20 years ago

Doc,

That is a GREAT sig.


Reply
Posts: 353
(@stempile)
Reputable Member
Joined: 19 years ago

HongKong LEDs - Leads to short for 1" spacing

I got a sheet of the 1" peg board. Found that the leads on the LEDs from Hong Kong are to short to connect without wire.

Not sure if I am going to drill closer holes or just start wire wrapping.

Also wondering about the focus. Seems to avoid bright spots all LEDs need to be angled the same way. Looks like it is difficult to do with the pre-drilled wood since the whole are just slightly to large for the 5mm LEDs.

ms


Reply
wjohn
Posts: 1102
(@wjohn)
Noble Member
Joined: 20 years ago

Matt,

1/2 spacing allows you to use the LED legs and just bend them in tohe direction required.

I am going with 15mm (2/3) inch for the same reason.

John.


Reply
Page 1 / 2
Share: