Pixel Question
 
Notifications
Clear all

Pixel Question

10 Posts
5 Users
0 Reactions
2,810 Views
Posts: 31
Topic starter
(@cayanke)
Eminent Member
Joined: 12 years ago
[#38519]

Hi all, I am having a small problem with a string of pixels. My question is do I need to add additional null pixels or is this problem associated with software?

Here is my setup:

Pi>DIYLED Bridge>DIYLED Pixel Extender>40 12V 2811 rectangular nodes divided into 2 sections of 20 with about 40ft of 16/3 wire. I have a single null pixel at about 20 feet. Power at the beginning and end, tried in the the middle and made not difference. Voltage drop is 1.2V full white with less than 1A throughout the power section.

I am sequencing and converting the files to FSEQ in Vixen 3.

Problem:
When I run a sequence with a pulse effect ramping up in blue, green and white (or various other color mixes) nearly all of the pixels ramp up as expected except for the last 12. Those last 12 flicker significantly. When I do it with red, it works as advertised.

All solid colors work just fine.

I think that the data piece is good to go because during other effects they respond as they should, I have checked connections and everything appears to be tight. I also think that power is good.

Is there anything else that I can check or is this an issue with the effects?

Thanks for all of the help...First year is starting to shape up...


9 Replies
Posts: 1049
(@phrog30)
Noble Member
Joined: 12 years ago

I could be the pixels. Do you have a string to swap and try?


Reply
Posts: 31
Topic starter
(@cayanke)
Eminent Member
Joined: 12 years ago

Unfortunately, I don't this time. Next year, I will have plenty of spares on hand.


Reply
Posts: 31
Topic starter
(@cayanke)
Eminent Member
Joined: 12 years ago

Is it likely/possible that it would be just the one pixel where the problem starts?


Reply
Posts: 31
Topic starter
(@cayanke)
Eminent Member
Joined: 12 years ago

Alright...now I know its a cable length issue. I direct connected that second set and have no problems. Now my question is regarding the wiring piece. I am using a 16/3 outdoor extension cord to connect the two sections. Would it be better to use CAT5 in this situation? Have people have poor results with the lower gauged wire? My basic understanding what that I would reduce resistance with the larger gauge. I know that works for power, but I have no idea what it does with data.

Thanks for the guidance.


Reply
Page 1 / 2
Share: