So I bought (2) Curtain lights for my upstairs siding to cover it (yellow) - They look great when I got them, but of course, I had to work around windows outside, so I had to cut some whole sections off. That was fine, One cut would take that section and the section one more over out - and that was perfect.
I needed to cover the bottom of the Windows, so I splices in cut sections to other sections, maybe them 2x or 3x the original length. In the house, it looked great - I didn't see a lot of difference (I did when I tried 4x on a section ... Really dim). So at any rate, I'm learning of course on this one - I have too many LEDs on that string and its not supplying enough power ....
So, is there any way to inject power to a section - say at the original end length of the string, before I spliced in another section?
Hope that makes sense....
LED lights are fixed current devices...meaning they are designed to be a certain bulb count (say 25, 30, 50, 60 count and more) and then they are controlled by placing resistors (blobs device in line with LED bulbs) to limit this current. What this does is control the brightness of the bulbs (by controlling the current going through the led). If you start cutting and splicing these prearranged light sets, you will either over current the LED (by shortening a string) or making them dim (adding too many leds to a string). You are asking for trouble if you do and not setting the resistor value back to a proper level to be within the 20ma LED limitation.
There is no such thing as injecting power in a 120V String. This is only for DC applications..NOT AC
Ah yeah - forgot about the AC and DC for injection (been doing too much on my pixels) - All makes sense and that's what I figured ... Thanks!
duramadmax wrote:LED lights are fixed current devices...meaning they are designed to be a certain bulb count (say 25, 30, 50, 60 count and more) and then they are controlled by placing resistors (blobs device in line with LED bulbs) to limit this current. What this does is control the brightness of the bulbs (by controlling the current going through the led). If you start cutting and splicing these prearranged light sets, you will either over current the LED (by shortening a string) or making them dim (adding too many leds to a string). You are asking for trouble if you do and not setting the resistor value back to a proper level to be within the 20ma LED limitation.There is no such thing as injecting power in a 120V String. This is only for DC applications..NOT AC
Weeellllll....... Sounds to me like he cut out entire sections that were 120v per section. If that is the case, cut and splice away if you make sure you do it right.. don't start cutting half sections or so.. then you will have some work to deal with in resistors and wiring..
And there is no need for any power injection on 120v strings.
I did full sections, and yeah - cut them at the root, no 1/2 or anything like that ... Problem is the sections that have been spliced are noticeably dimmer - Not too bad at full, but any dimming event makes it really apparent....
