Had the weirdest thing this year. I have four arches made with one piece of 3/4” by 10 ft pvc with eight 15” segments of 1” thin wall pvc wrapped with 100 each of warm white and red leds. I put two pieces of rebar into the ground at an angle and flex the arches over the ends of the rebar to create the arch. Well, this year one of my arches had the last led string (white) on one end that stayed dimly lit during sequences and all night after the show was over. I could start sliding the end of the arch up off the rebar and the lights would dim to completely off. As I slid the arch back down the rebar the leds would slowly get brighter. Other than that, the arch worked perfectly. A snubber on the string made no difference. I can’t figure out what could have caused it. Using three prong extension cords so there is a ground. Anyone else ever have this problem?
Strange! Sounds like you're using that new isotope infused rebar. Watch out for stray gamma rays. 🙂
Are there either buried or overhead power lines nearby? With rebar at the ends and wrapped wiring you may have created an inductor.
Leakage current through the triac. Replace the triac.
ezellner wrote:Are there either buried or overhead power lines nearby? With rebar at the ends and wrapped wiring you may have created an inductor.
I would like to add if it is induction from buried cable and you are that close to it with your rebar, you may want to consider calling the local electric utility to have the rebar removed safely.
To help diagnose induction turn the arch around end for end and 1 of your other arches and see if the problem moves or stays put.
Ron
ezellner wrote:Are there either buried or overhead power lines nearby? With rebar at the ends and wrapped wiring you may have created an inductor.
The closest underground wires are over 60 feet away. The only possible wiring that could be in the ground anywhere close to the arch would be a sprinkler system which is low voltage but I don’t think there is anything there.
jklingert wrote:Leakage current through the triac. Replace the triac.
When I took my display down, I took the arch and the controller into my garage and plugged them up
With no illumination of the led’s at all.
Amigorick wrote:When I took my display down, I took the arch and the controller into my garage and plugged them up
With no illumination of the led’s at all.
The moisture level is different in a dry garage and you did not have a metal stake that was close by that was grounded. take an ac voltmeter and read the voltage across the channel when it is off. I bet it is not 0volts. Small leakage currents can dimly light leds. Most obvious on damp/ wet nights. My experience is that cheap half wave leds are the worst culprits to glow when off.
Thank you for the information!! It probably doesn’t make
A difference but all of the leds on my arches have the full wave
Rectifier boards I got from a member in this group. I will check the
Voltage and just replace the triac if necessary!
I get the same problem all the time on my mini-trees. It gets worse when it rains or snows. It is a grounding effect since they are on tomato cage frames and anchored to the ground. I can tell you how wet it is by how many trees are glowing.
