Switching lights in...
 
Notifications
Clear all

Switching lights inside inflatable

11 Posts
9 Users
0 Reactions
22.4 K Views
Posts: 218
Topic starter
(@ailgup)
Reputable Member
Joined: 17 years ago
[#11437]

Hello , i want to be able to use the lights inside my inflatable as a channel, but an wondering how to do so, i want the blower to be plugged into the wall (so it stays inflated) and to switch the lights as i wish. I looked inside of it and was wondering if i could just cut the wire going from the base to the lights and then run that to my renard controller. My concern was that the four c7 bulbs would not be able to handle the power and burn out? has anyone done this and if so how?

thanks in advance for all the good advice,
chris


10 Replies
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

I know I've seen this done in other threads - you should be able to run the C7's on a separate circuit with no problems since they are usually just wired in parallel.


Reply
daviddth
Posts: 925
(@daviddth)
Prominent Member
Joined: 19 years ago

I actually removed the bulbs and placed a led portaflood in the base of all my blowups. Works well


Reply
Posts: 218
Topic starter
(@ailgup)
Reputable Member
Joined: 17 years ago

okay sounds like it should work thanks all!!!


Reply
Posts: 1424
(@oldcqr)
Noble Member
Joined: 18 years ago

I have a whole DIY article on exactly what you are trying to do:

Electrical Modifications for Inflatables


Reply
Page 1 / 3
Share: