Notifications
Clear all

Modify Audio Level

6 Posts
4 Users
0 Reactions
4,117 Views
Posts: 1763
Topic starter
(@santacarl)
Noble Member
Joined: 19 years ago
[#35965]

Hi All,

I'm trying to raise the audio level on a freshly created sequence.....using the "Modify Audio Level -- Up or Down" menu option. I can't seem to get it to work. I've tried several approaches and can't get it to work. Usually when I experiment with HLS I usually go about it the wrong way and try everything but the right way....and usually that means I didn't follow the correct sequence of steps.....as I'm not very intuitive that way....

Can someone give me the order to use? Do I analyze to get current level first....or just put in a number and hit OK.....(tried both in 1 form or another to no avail).... When I first bring the tab up everything is set to 0....if I hit analyze it says my current maximum level is 32754.....but I can't increase it by putting a larger number in the "requested maximum level" box.....it either locks up or returns a negative number..... The 1 time I got it to change I left the requested max at 0 and of course it did that and my audio went away..... I can't seem to get it to increase.....

Thanks

SC


5 Replies
Posts: 3650
(@jhinkle)
Famed Member
Joined: 15 years ago

If you killed your audio - there is no way to raise THAT dead corpse from the dead.

Start a new sequence - selecting that SONG again - thereby creating the audio file.

Move the newly created audio file into the existing sequence (replacing the bad one) and then delete the temp sequence just created.

Joe


Reply
intwoit2002
Posts: 412
(@intwoit2002)
Honorable Member
Joined: 18 years ago

Welcome back Joe.


Reply
Posts: 1763
Topic starter
(@santacarl)
Noble Member
Joined: 19 years ago
JHinkle wrote:If you killed your audio - there is no way to raise THAT dead corpse from the dead.

Start a new sequence - selecting that SONG again - thereby creating the audio file.

Move the newly created audio file into the existing sequence (replacing the bad one) and then delete the temp sequence just created.

Joe

Yeah....kinda figured I'd killed it and since I had gone no further than assigning the audio I just deleted the whole thing and started fresh....loaded the same SONG from the original 'good' wav file.....Now what do I do to get the audio level up just a bit?


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

load the song into audacity and increase the db gain 🙂


Reply
Page 1 / 2
Share: