I'm working on integrating the Ether-Node along with an E6804 into the Helix system.
For some reason the Ether-Node is not linking with the E6804.
So far, I've set the IP on the E6804 to 192.168.10.11. The term jumper for RS-485 comm is set on both the main network controller and the ether-node (3rd and last ID; I have a main board (ID 2) in the middle, the term jumper removed).
I can access the E6804 web page from my laptop, but the Ether-node does not appear to link with it. I've tested my network cables and they're good.
I've also verified I have the correct SD cards are in the correct controllers with their files.
The Ether-Node is showing it has a connection to the network.
I've added the ether-node in HNS 3.2 and setup the E6804 as 192.168.10.11 for the config.
I'm not sure what I'm missing.
Is there any more testing someone can suggest I do to troubleshoot?
I've been thinking of trying to play a short sequence from my laptop, through the E6804. That would be tonight. But, not sure what I can do to test the Ether-node controller.
Sent from my iPhone using Tapatalk
Last night, I noticed the heartbeat LED on the Ether-Node is not blinking. But, the Wired RX LED flashes.
Anyone run into this?
Sent from my iPhone using Tapatalk

My E6804 config
Sent from my iPhone using Tapatalk

Helix Network Controller
Sent from my iPhone using Tapatalk

Helix Network Node
Sent from my iPhone using Tapatalk
