I think I have a Grinch issue. My display was working fine a few days ago, but after a big snow fall my display hasn't been working. When I play a program through vixen the display plays randomly and doesn't play the program correctly. The Grinch is located outside in a plastic box covered with a garbage bag. I looked at the circuit board and it doesn't look like it got wet or anything. The LED shows it has power. I checked all the cables and used 2 different computers and the display still plays randomly. Could this be a Grinch issue? Should i try to swap the MIB chips? Or would it be the capacitors? Why would it now work?
Any help would be great
Thanks
I'd still check the main cable from the PC to the Grinch first. You'd have to run a continuity check there to make sure it's solid.
If a test of channel 7 (pick any channel) lights a different channel instead but always a channel within the same chip's control (each chip controls 16 channels), then I'd do the following:
I'd remove the chips, use a can of compressed air (for cleaning computers) and blow them out. If you're not using chip sockets, then at least use the can of air to blow out around/under the chips.
Do the same to the RJ45 jacks and the RJ45 plugs -- make sure they're dry. If the cable end of the Rj45 plugs is open (e.g. not sealed) then you might have a little moisture down in there, too.
After that, you might take some alcohol and a rag and lightly wipe both the top and bottom of the board with a damp (not soaking) rag. The alcohol will absorb any surface moisture and when it dries, you'll have a very dry board.
Then test the same channels again, if the problem goes away for that chip, then moisture was the problem.
Other than the above, I don't think theres much else that can go wrong with a Grinch other than something died on the board.
BTW, Welcome to DIYC!!!
Thanks, I figured out the problem.
It was the main cable from the PC to the Grinch, it wasn't working correctly. Its all fixed now.
Thanks for the help, I'm glade to be apart of DIYC
Good job! Glad it's working again!
Merry Christmas!
