MPLab Pickit 3 Sure
 
Notifications
Clear all

MPLab Pickit 3 Sure

1 Posts
1 Users
0 Reactions
2,046 Views
buymyemu
Posts: 638
Topic starter
(@buymyemu)
Prominent Member
Joined: 16 years ago
[#20914]

Last year I build a Ren48lsd and managed to program the PIC's using my Sure Pickit 3.

I just spent the last 4 hours trying to program a new REN48lsd set of chips with no results until....

I took the old unit swapped out the first pic into the new, everything worked, so I knew i had a PIC problem
Went back and found an Adobe document... select device, set the power, Mplab displays 0006. then did file/recent, loaded the same hex file as i did last year.

Clicked program, MPlab says programmed/verified, popped chip into old and new ren48 just got the red lights stuck on (pic not programmed).

Back to MPLAb, tried different usb ports etc. Downloaded another hex copy from DIYC, same results...

Then, after 4 hours, i decided to put in the known working PIC, and clicked Read on MPLAB.

The checksum value changed on the screen from xFFF to 0aF7.

I then put in the new chips and programmed all with no issues.

So, my question is, did I miss a step after doing File/Load (of the Hex) and then clicking Program? When I do that the checksum value does not change on the MPlab screen, I still get program/ verify, but the chip is blank.

Why did MPlab not take the hex, but did take the read of the old chip?

(The REN48lsd works perfect with the new chips now)


Share: