I would like to go back to LOR software. I'm using Renard equipment. What would I need to do to use the LOR software with Renard equipment. I know that I would have to use the iDMX that LOR sells and change the chips over to the DMX firmware. Will the equipment work with the software?
S3 now supports native DMX and the Enttec DMX Pro USB adapters.
I do not have any DMX Renard boards programmed to test with now but it appears to recognize RPM's dongles.
-Craig
I sent in for the upgrade to my S2 setup - I've heard there are issues with DIY dongles because they are not full emulations of the Enttec Pro and that it won't be fixed until 3.1 (next year) and also no E1.31 support - that's too bad but I look forward to seeing the new features.
Well, I have Half a Ren 64 progammed with DMX now. Did a short test.. One dongle seems to work fine. The other is erratic. I've never tested the dongles, so the bad one might have a problem.
With the good dongle on a short S3 sequence, so far, it steps, fades, even twinkles and shimmers as it should. 🙂
-Craig
The Entec issue is supposed to be fixed with LOR version 3.0.4, due to come out shortly.
