LED "flutter"
 
Notifications
Clear all

LED "flutter"

16 Posts
4 Users
0 Reactions
16.1 K Views
Posts: 1387
 kev
(@kev)
Noble Member
Joined: 12 years ago

Duplicate


Reply
Posts: 1387
 kev
(@kev)
Noble Member
Joined: 12 years ago

Victor_PV sketch uses a header. You can find the sketch on this site. If you use it, it already has the digitalWrite code in it. You would add a header of ~! to the header dialog box in the Vixe n controller section (where you adjust the band rate). A lot of people use the Victor sketch.

http://doityourselfchristmas.com/forums/showthread.php?35505-Simple-code-for-Arduino-Uno-Mega-Up-to-48-realy-SSR-channels-with-Random-mode


Reply
Posts: 12
Topic starter
(@empac99)
Active Member
Joined: 8 years ago

So, being unable to eliminate the "flutter" for my Christmas display, I removed my newly-constructed Arduino control box and plugged my lights directly into the wall outlet. There was no flutter in any of the lights. This leads me to think perhaps my 5v/2amp power transformer was the source of the flutter. I'm just wondering what other members of this forum think is the likelihood that investing in a better power transformer would eliminate the undesirable flashing of lights when I am switching them on and off through my control panel. The 110 voltage is the same either way, the difference being I have a POSSIBLE culprit in the transformer. Possible?


Reply
Posts: 1387
 kev
(@kev)
Noble Member
Joined: 12 years ago
empac99 wrote:I'm running 2 Sainsmart 8 channel SSR's. I don't see other distinguishing markings on them.........

Upon re-reading this thread, I just noticed that you are using the Sainsmart SSR's. If you have the $20 version of the SSR's, they can not dim correctly. Sainsmart has a newer SSR listed on their site for $42 that may dim, but I don't know as I have never used them.

A short video of the "flutter" might help us.


Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

And at what brightness do they flutter? Create a sequence that cycles through Full on dimming to off and then back on over a 10 sec period. Most likely you ar only outputting a quick pulse to the SSR. For LEDs you need to have the SSR signal on for the entire on period.


Reply
Page 3 / 4
Share: