LED "flutter"
 
Notifications
Clear all

LED "flutter"

16 Posts
4 Users
0 Reactions
16.1 K Views
Posts: 1387
 kev
(@kev)
Noble Member
Joined: 12 years ago

what sketch are you using? you could be losing synchronization of the data stream. I use cheap led strings and don't notice flickering until I dim them a lot. As Martin asked, what SSR are you using?


Reply
Posts: 12
Topic starter
(@empac99)
Active Member
Joined: 8 years ago

I'm running 2 Sainsmart 8 channel SSR's. I don't see other distinguishing markings on them. I have 3 strings of GE StayBright 216-Count 19.6-ft Multicolor Integrated LED Plug-In Christmas Rope Lights. These are mount-and-leave "tape" lights.

Sketch as follows:
#define MEGA_VIXEN
//#define UNO_VIXEN

#ifdef MEGA_VIXEN
#define MAX_CHANNELS 16
int channels[MAX_CHANNELS] = {2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13, 14, 15, 17, 18};
#endif

#ifdef UNO_VIXEN
#define MAX_CHANNELS 18
int channels[MAX_CHANNELS] = {2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12, 13, A0, A1, A2, A3, A4, A5};
#endif

int incomingByte[MAX_CHANNELS];

void setup()
{
int i;

Serial.begin(9600); // set up Serial at 9600 bps

for ( i = 0; i < MAX_CHANNELS; i ++ ) pinMode(channels, OUTPUT);
}

void loop()
{
int i;

if (Serial.available() >= MAX_CHANNELS)
{
for (i = 0; i < MAX_CHANNELS; i ++) incomingByte = Serial.read();
}

for (i = 0; i < MAX_CHANNELS; i ++ ) analogWrite(channels, incomingByte);


Reply
Posts: 12
Topic starter
(@empac99)
Active Member
Joined: 8 years ago

I also have four 8" stars with incandescent mini bulbs, 8 candelarias, each with a C7 incandescent bulb. Finally there is a small LED flood light that lights up my Mr. Grinch at the appropriate parts of his theme song. All sequences are run on Vixen 3.5u3


Reply
Posts: 1387
 kev
(@kev)
Noble Member
Joined: 12 years ago

Try changing analogWrite to digitalWrite and add a section of code to turn off (low) or on (high).

instead of this -
for (i = 0; i < MAX_CHANNELS; i ++ ) analogWrite(channels, incomingByte);

Try this -
for (i = 0; i < MAX_CHANNELS; i ++ )
if (incomingByte < 127) {
digitalWrite(channels, HIGH);
}
else {
digitalWrite(channels, LOW);
}

Also, this sketch does not have a means to synchronize the data. Some sketches look for a header or footer and sync off of those.


Reply
Posts: 12
Topic starter
(@empac99)
Active Member
Joined: 8 years ago

I'll make those changes tonight. Thanks! Where do I access info on header/footer?


Reply
Page 2 / 4
Share: