Zero Crossing help
 
Notifications
Clear all

Zero Crossing help

15 Posts
5 Users
0 Reactions
6,863 Views
Posts: 274
 Matt
Topic starter
(@matt)
Reputable Member
Joined: 19 years ago
[#1138]

Neither of my two Ren64s are working.

According to a PIC with the diagnostic code, everything is working fine except the zero-crossing signal. I have no idea where to go from here, but here is what I have:

- The power LEDs on both the Ren64 and the Ren-T are lit.

- I built my own Ren-T on a breadboard. The transformer is a radio shack 273-1365. I have tried building it twice over with no luck either time. I used the parts list on the Wiki (D1, D2, D3, R1, R2).

- On the Ren64, I've populated R9 and Q1. I checked continuity and everything has a good solder connection.

- J2 on the Ren64: the shunt is between pins 1 and 2 (closest to the PCB edge).

Any ideas on what I am doing wrong or what I should check next?

Thanks,
-Matt


14 Replies
RavingLunatic
Posts: 1502
(@ravinglunatic)
Noble Member
Joined: 19 years ago
- J2 on the Ren64: the shunt is between pins 1 and 2 (closest to the PCB edge).

Really that is pins 2 and 3, with that in mind which pin of the RJ45 IN connector are you bringing in your ZC. It should be 7/8 not pin 3

Do you have an oscilloscope to see what the ZC coming out of your version of Ren-T looks like?


Reply
Posts: 274
 Matt
Topic starter
(@matt)
Reputable Member
Joined: 19 years ago

Yes, power (+) and ZC are on 7/8.

I was thinking the same thing - I wish I had an oscilloscope, but I don't. Any other advice?

-Matt


Reply
Wayne J
Posts: 7789
(@wayne-j)
Illustrious Member
Joined: 20 years ago
Matt wrote:Yes, power (+) and ZC are on 7/8.

I was thinking the same thing - I wish I had an oscilloscope, but I don't. Any other advice?

-Matt

Is your ren-T built following this schematic?


Reply
Posts: 274
 Matt
Topic starter
(@matt)
Reputable Member
Joined: 19 years ago

Yes.

-Matt


Reply
Page 1 / 3
Share: