Ethernet Question
 
Notifications
Clear all

Ethernet Question

7 Posts
5 Users
0 Reactions
3,665 Views
Posts: 116
Topic starter
(@ruthless)
Estimable Member
Joined: 10 years ago
[#46459]

OK so I have 2 LOR boxes and 4 Renard ss24s. I have the LOR USB485 USB to Ethernet Dongle and a JBtek USB to RS485 Usb as well. I used to be a techie back in the day and can wire my own ethernet. What I want to know: Am I terminating the ethernet is the typical CAT6 or 5e fashion, or is there a different orientation for 1) computer to first box 2) different for the box to box Daisychain?

Thanks in advance!


6 Replies
mikeh65
Posts: 794
(@mikeh65)
Prominent Member
Joined: 19 years ago

I think what you are asking, is cable setup. I'm not sure for LOR, but all Renard cable connections are standard pass through. No special wire arrangement is needed. Same cables are used to go from computer to box as box to box in the daisy chain. I believe the same applies to LOR, but having not used them, can't say for sure.


Reply
Posts: 191
(@davemck)
Estimable Member
Joined: 10 years ago
Ruthless wrote:OK so I have 2 LOR boxes and 4 Renard ss24s. I have the LOR USB485 USB to Ethernet Dongle and a JBtek USB to RS485 Usb as well. I used to be a techie back in the day and can wire my own ethernet. What I want to know: Am I terminating the ethernet is the typical CAT6 or 5e fashion, or is there a different orientation for 1) computer to first box 2) different for the box to box Daisychain?

Thanks in advance!

LOR and Renard both use pins 4,5 for the signal. There is a Wiki that talks about using them together at http://www.doityourselfchristmas.com/wiki/index.php?title=Using_LOR_Controllers_With_Renard

Sent from my XT1650 using Tapatalk


Reply
Posts: 116
Topic starter
(@ruthless)
Estimable Member
Joined: 10 years ago
DaveMcK wrote:LOR and Renard both use pins 4,5 for the signal. There is a Wiki that talks about using them together at http://www.doityourselfchristmas.com/wiki/index.php?title=Using_LOR_Controllers_With_Renard

Sent from my XT1650 using Tapatalk

Thanks Dave.. so in that wiki, there is a section "programming Renard to run in DMX" however it's empty. Is a reprogramming required? Can you point me in the right direction?

Sent from my iPad using Tapatalk


Reply
Posts: 191
(@davemck)
Estimable Member
Joined: 10 years ago
Ruthless wrote:Thanks Dave.. so in that wiki, there is a section "programming Renard to run in DMX" however it's empty. Is a reprogramming required? Can you point me in the right direction?

Sent from my iPad using Tapatalk

Yes, if you want to switch protocols you have to get a pickit tool and reflash the PIC. I will let those more experienced weigh in on best source and best approach to this task.

Sent from my XT1650 using Tapatalk


Reply
Page 1 / 2
Share: