FPP to 2 E682 contr...
 
Notifications
Clear all

FPP to 2 E682 controllers = massive network/sequence errors

14 Posts
6 Users
0 Reactions
5,611 Views
Posts: 33
Topic starter
(@raabaman)
Eminent Member
Joined: 11 years ago
[#42204]

I'm trying to connect my 2 E682 controllers to my RPi running FPP. When I run the controllers individually from the FPP all is well. When I connect the second controller, through a unmanaged switch it all kind of falls apart.

I'm not saying that the controllers don't work when both connected up. They do. They just have pauses that are super noticeable. When I put the FPP into test mode and run a simple chase it goes correctly (on both controllers) for 1 second, then pauses for a bit, then runs again for a second or two, then pauses..... It's not the chase. If I run the same chase on one controller it's seamless. It just runs continuously as expected.

I can see that data is getting to the controllers by seeing the "Packet Count" go up on the controllers web-settings page. It also shows that there are numerous errors in the data.

The controllers have been updated to the very latest firmware 5.018 (**correction** I just noticed there is now a version 5.018-01) Both are set to the same configurations. I am only enabling 4 strings of 100 pixels. Each string is 1 universe - 510 channels.

I have also seen the same type of problem when I try to connect my laptop to the switch. It will not make a sustained connection. It connects then disconnects every second or so.

This has got to be a network setting problem. I just don't think I understand it well enough. I am also assuming that the problem is in the way I've configured the FPP network setup.

The RPi/FPP is connected via wifi to my home network(192.168.1.). I then set the ethernet port on the RPi/FPP to be a separate subnet(192.168.100.).

What have I done wrong??

It's confusing so I'm including a few pictures to help get the point across.

Cheers!

FPP network2
channel output
FullPicture
E682 1 ALL
E682 2 ALL

13 Replies
sporadic
Posts: 1199
(@sporadic)
Noble Member
Joined: 14 years ago

Turn your sequencer off?


Reply
Posts: 33
Topic starter
(@raabaman)
Eminent Member
Joined: 11 years ago
sporadic wrote:Turn your sequencer off?

Not sure if you mean the controller's built in tests. Both of the controllers have the "Test Pattern" set to "Off".


Reply
ThinkAgainAgain
Posts: 230
(@thinkagainagain)
Reputable Member
Joined: 12 years ago

Yes, you can't have your sequencing software running while you're running your falcon


Reply
Posts: 1592
(@ruppro)
Noble Member
Joined: 11 years ago

The Network configuration you have looks sound and should work fine. Sounds like the switch is having issues, both the controllers and your laptop are having problems when connected to the switch, replace it and see if that makes a difference (you can always return it if not)

Raabaman wrote:I'm trying to connect my 2 E682 controllers to my RPi running FPP. When I run the controllers individually from the FPP all is well. When I connect the second controller, through a unmanaged switch it all kind of falls apart.

I have also seen the same type of problem when I try to connect my laptop to the switch. It will not make a sustained connection. It connects then disconnects every second or so.


Reply
Page 1 / 3
Share: