Notifications
Clear all

Rj45

6 Posts
5 Users
0 Reactions
3,165 Views
polar bear
Posts: 195
Topic starter
(@polar-bear)
Estimable Member
Joined: 18 years ago
[#6716]

Hi, i have just purchased from jaycar some RJ45 units that we need to put on the PCB's but they dont corespond to the hole placements it is as if they are back to front, has any one else had this problem. thanks


5 Replies
toodle_pipsky
Posts: 1285
(@toodle-pipsky)
Noble Member
Joined: 19 years ago

No they're different sizes, from memory I think they're smaller than the holes. The ones from Futurlec will fit and they're also cheaper, but they do come from Bangkok.

I haven't heard of anyone getting them to fit, but then I've never asked! I'd say if you can take them back and either get your money back or store credit and get the ones from Futurlec.


Reply
Matt_Edwards
Posts: 2664
(@matt-edwards)
Famed Member
Joined: 18 years ago

They wont fit. the pin out are different for the Low profiles ones.
I bought some too as I like the concept. but decided not to design them in.
I would take them back if you can.
KR
Matt


Reply
Posts: 556
 jpb
(@jpb)
Honorable Member
Joined: 19 years ago

Altronics ones fit. I think I used the P1448 @ $1.85 a pop

I will be able to double check this if you need.

Jon


Reply
polar bear
Posts: 195
Topic starter
(@polar-bear)
Estimable Member
Joined: 18 years ago

Thank you all, I only bought 3 of them as i was fed up waiting for the others to arrive from futerlec, but i was rather concerned that none would fit. thanks again

have just returned from the logic shop, it would appear that there is: a standered type with a stagger left to right, a standered with a a stagger right to left and low profile types for different applications, the owner has now found out he has 200 of the wrong type all of which dont fit our boards. thanks again for your help


Reply
Page 1 / 2
Share: