Interactive "DMX" s...
 
Notifications
Clear all

Interactive "DMX" show button

11 Posts
6 Users
0 Reactions
5,700 Views
Posts: 1041
(@n1ist)
Noble Member
Joined: 19 years ago

I'm not sure the display/button solution is the best choice for this. A better choice would be to use the front-end circuit from Renard to allow the input port to be connected to a PC's serial port (or to use a processor with USB) and a program on the PC to configure the patch. Depending on the number of patched channels allowed, we may need a processor with more RAM, like the ATMega324. It looks like we will need 512 bytes for the packet buffer, 512 bytes for the patch index table, 2 bytes per patch, and a bit for stack and local variables. If we don't allow multiple patches (ie, 1 input feeding multiple outputs), it becomes 512 bytes for the buffer, 1k for the patch table, and a bit extra for overhead.

I'll post some code excerpts from my DMX Status display (RX) and DMX Tester (TX) tonight (they are at home right now...)


Reply
Posts: 1041
(@n1ist)
Noble Member
Joined: 19 years ago

Here's one possibility...


Reply
Posts: 2630
(@dynamoben)
Famed Member
Joined: 19 years ago

Before we get too far, keep in mind that you can "trigger" vixen already. The trigger fires a sequence. So in your example your base sequences wouldn't do what they normally do. Then when a trigger occurs your RGB lights would be run with a seperate sequence. This feature is used a fair amount by the halloween crowd.

Look here:
http://doityourselfchristmas.com/forums/showthread.php?t=347&highlight=trigger+plugin


Reply
Posts: 7
Topic starter
(@gogoharry)
Active Member
Joined: 18 years ago

I know Vixen has triggers and there are some other computer-based options to get triggers working. This is was I thinking before I wanted to start such a project.

One place where I want to put such a button has no computer, here the DMX comes out a simple light-console. (I already looked for a existing button on the console which could do the trick so I only had to extend this button, but such a button isn't there).

In here I only have a DVD-player and this lightconsole so a "solution" which is DMX-only has my preference. (I already modified this console a little to get it in-sync with the DVD-player, the console had a sound to light feature with microphone, I removed the microphone and hooked it to the centerspeaker-out of the DVD player. The DVD-playing has only cues (Bass-tone+High-Tone) on the center-channel to push the console to the next scene in the sequence.)

This project is to keep it "simple" ....


Reply
Posts: 7
Topic starter
(@gogoharry)
Active Member
Joined: 18 years ago

I think I'll take the dsPIC30F3013 microcontroller. This one has 2 UARTs and enough memory. This one is available in a SDIP-28 package, which is not too big and quite easy to use in DIY projects.

About the programming I was thinking to fill a RX-Buffer when a DMX Signal is received. And a TX-Buffer which is filled with the contents of the RX-Buffer when the button isn't pressed. But when the button is pressed there is a "patch-Table", for each channel/byte in the TX-Buffer there will be a lookup in this patch-table which channel/byte of the RX-Buffer will be used for that particular channel.

I found that the dsPIC30F3013 also has a SPI output, but it shares the output/input pins with one UART. Does anyone know if the SPI can be used when the output of the UART is set to it's alternative output-pins ? (This maybe for some SPI-controlled future expansion)


Reply
Page 2 / 3
Share: