Somewhat small pixe...
 
Notifications
Clear all

Somewhat small pixel controller

11 Posts
4 Users
0 Reactions
4,516 Views
Posts: 6728
Topic starter
(@p-short)
Illustrious Member
Joined: 20 years ago
[#26140]

Here are some pictures of a small controller that I'm working on. Yesterday I debugged the firmware, which is based on the Renard-PX1 firmware. I've mentioned this before in the Renard-PX1 thread in the development forum, but finally got it working yesterday. The board is slightly larger than what I mentioned before, its now 0.375" x 0.85" in size.

The first two photos show the board that I used for debugging. In 'real life' the pixel string would be soldered to the three center vias at the bottom, and power would be brought in on the two outside vias at the bottom. The three-pin header in the middle of the board would be used for programming the PIC (along with power and ground). The three-pin header at the very top is the RS485 input to the board, and the one below that is the RS485 output. The components on the front side of the board are RxD and Frame_Error LEDs and their series resistors, along with a bypass cap at the bottom. The chips on reverse side of the board are the RS485 transceiver (second figure, at the top) and a PIC12F1840.

The green connector and the wires running off to the right (first thumbnail) are there just for the debugging process.

100 0501
100B0642
100B0610
100 0496

10 Replies
LabRat
Posts: 2981
(@labrat)
Famed Member
Joined: 17 years ago

Replace the 485 with an IR receiver.. and you've got the portable pixel hat controller. :biggrin:


Reply
Posts: 6728
Topic starter
(@p-short)
Illustrious Member
Joined: 20 years ago
LabRat wrote:Replace the 485 with an IR receiver

and the right firmware

.. and you've got the portable pixel hat controller. :biggrin:

Reply
LabRat
Posts: 2981
(@labrat)
Famed Member
Joined: 17 years ago

Uh yea.. I thought that part was a 'given'. But sure.. yeah.. need that too.

Got a 12F1822 here hooked to a five LED strand of 2811's. I just never seem to get to it these days.


Reply
Posts: 225
 amps
(@amps)
Reputable Member
Joined: 15 years ago

This is great. I need a nice small controller for my roof line Pixabulbs. Looking forward to the final version.


Reply
Page 1 / 3
Share: