P. Short wrote:Nothing special about 115200, other than it's the fastest rate that you can get out of a standard serial under Windows. It's no problem to run slower, and I'd like to be able to get 230400 out of a standard serial port.
I am running an FPP this year supporting 2 Sandevices E682's, of which the first is running 216 channels of Renard at 57600. I thought I was limited to 115200, but I can use the PX-1 at 57,600 with no problems? Would there be any limitations here other than channel count since I am not running via serial port?
Thanks,
Keith
s/b fine.
lmercor wrote:I will check on that. I have changed the settings on the asm file to match the baud rate and then built it again to generate the hex. I'm using a JDM programmer and PICPGM to program the microcontroller not the PICKIT as recommended on the main pixel PX1 page. I will check the asm again, and check the conf word for the PIC at the time of programming.Thanks for the tips
I will let you know the result.
Thanks
Luis
Turns out that the problem I had was the power supply. Probably was injecting a lot of noise. I switch it and start working like a charm.
Is it possible to drive 400 pixels using 2 PX1 (200 per controller) and one serial port? is the serial port working at 115200 fast enough to drive them all and be able to create effects?
Thanks
Luis
You'll get about 8 updates per second with that setup (115200/(400 * 3 * 11)) if you are using a group size of 1, so you might not like the results.
I am having problems with my PX-1's. I have 50 node strings connected to 4 px-1's. Used the utility to set 57600 baud, group size = 1, group count = 50 and the com5 port of my 485 plug. Hit write and get lights flash & ok message. Start up xlights and set renard, 57600, com5 and last channel 150. Setup element single line , string =1 , node/string = 50, lights / node = 1 and string type = rgb. Create a seq and drop an effect and all the lights do the same thing. I have a string of 22 pixels on a wireless renard controller and if I put butterfly on it all the pixels have different colors. I am stuck. Have also tried lights/node =3 and same thing. Any help would be great. Must be something simple I am overlooking. Thank You. Bob Craig.

