P. Short wrote:Does anyone have a spec for the 2801 with good timing information in it? There is a 15-page preliminary spec out 'there' that I've downloaded, but it isn't sufficiently comprehensive to design to.I've taken jstjohnz's suggestion above for use on the Renard-px1. It works fine on my copy of the px1 and a ws2801 string that jklingert sent to me, but he is having problems with ghosting and bad pixels (on strings that work fine with the E681). I've tried slowing the clock down and modifying the data waveform, but the fixes don't work on all of the strings. So I'm suspecting that there might be something in the spec that is affecting operation.
Anyone?
Most of my problems with driving WS2801 strings cleared up when I increased the reset to just over 1 mS. The preliminary spec that I mentioned above only calls for 500 uS.
Phil,
I am just learning all this new stuff with pixels. What I read was the following:
"CLK pin keeps low more than 500uS will make the WS2801 internal status register reset, and at this moment, the gray scale data in the data shift registers will be latched."
There may be timing tolerances that come into play. I could be way off base here. I am still looking for the actual Data sheet too.
Just an observation.
Dave
That's what I was looking at. The reset was already out past 500uS, so I was surprised that increasing it further made any difference. But it did, so I suspect that the reset does more than just that, or that the shorter reset was screwing up something else. What I observed was 'ghosting', the values for a given pixel were flickering in and out on the next two pixels (frequently on the next pixel, occasionally on the second pixel).
Were those problems eliminated when you increased the timing of the clock ?
Dave
New to pixels here.
Is it possible to run WS2801 and WS2811 strings on the same controller or would it require a second controller? I assume that a second PX1 would be needed.
Yes, a second controller would be needed if you want to run both at the same time using px1 controllers. It's a different story with he various E1.31 controllers/bridges that people have created. They have multiple output connectors, which afaik can each talk to a different type of device.
P. Short wrote:Yes, a second controller would be needed if you want to run both at the same time using px1 controllers. It's a different story with he various E1.31 controllers/bridges that people have created. They have multiple output connectors, which afaik can each talk to a different type of device.
Thanks, that's what I thought.
How is this board progressing?
Jrd wrote:How is this board progressing?
Progressing well. Beta test is about to start as soon as the boards come in. 🙂
http://doityourselfchristmas.com/forums/showthread.php?26909-Renard-PX1-BETA-Test
Wayne J wrote:Progressing well. Beta test is about to start as soon as the boards come in. 🙂
http://doityourselfchristmas.com/forums/showthread.php?26909-Renard-PX1-BETA-Test
Thanks Wayne, didn't see that thread. It would be nice if new threads for this project were linked to from here, especially the interest thread when it comes.
