Litebrite wrote:I'll sub to follow along. I use PoE daily as a network admin. I have often thought of trying to design a PoE switch meant for controlling and powering pixels.
This doesn't follow the traditional POE standard. I am using 6 conductors for power so I can source the buck with more amperage. Pins 5 & 6 I am using for differential data.
ngen33r wrote:I am looking for 144W at 500' minimum with data and power on a cat 5 cable. The advantage is I don't want 5V & 12V power bricks all over my yard with 5000' of extension cords at 120VAC. The ideal application is small ornaments and arches. My design requirement is to power 2 x 5M 5050 WS2812 LED strips (600 pixels).
Ok, at 500ft, I get it. I'd volunteer to help you test, but I have a small yard.
Awesome. I will let you know when I have a receiver built and tested. I need to purchase a Falcon controller. I have a Coro controller, but I currently don't want to use their products.
So I had more time to play with this and I need to change the mosfets and add some heatsinking. The supply is stable with 48V input and a 1 ohm load drawing close to 12A drawing and 3A from the 48V supply. So once I get the thermals happy this should power 2 600 pixel WS2812 12V LED strips if feeder lines are added in the middle and end. While the supply is efficient, I know the 12V strips are not so I will continue to work on the 5V version. I will most likely switch to a thru hole mosfet to make adding heatsinks easier. I don't have the space on the board for 6sqcm of thermal plane for each mosfet and even with that, I am about at the dissipation limits of the device. Custom machined heatsinks are out of the question for a hobby device.
I wondered how your project was coming along. Thanks for the update.
