Possible cheap stro...
 
Notifications
Clear all

Possible cheap strobes

13 Posts
6 Users
0 Reactions
6,728 Views
Posts: 188
(@awhaley)
Estimable Member
Joined: 18 years ago

The per channel rating on a grinch is 90ma.... so you can run one led at 90ma, or 3 at 30... etc, assuming you're running it off 5v... the grinch can handle up to 17volts on the output side, so you could run 5 3v leds in series at 90ma. For strobing, there's probably some 'headroom' given that you're leaving everything on for no more than .1s, but there's no way to calculate that, so all I can do is quote the 90ma off the data sheet. 🙂

Art

Edit: You ALSO could come up with a pretty simple solution to switch small (but larger than 90ma) loads from the grinch with a transistor or mosfet....


Reply
RPM
Posts: 1080
 RPM
(@rpm)
Noble Member
Joined: 19 years ago

I was considering using some of these to see how they do... I know that they draw 100ma because they are basically 5 LED's in one 10mm package. Are these the ones you used?

Robert

fkostyun wrote:If your looking at camera strobes - I believe firegod did a nice setup a last year.

Personally - I have found that high-current LED's work GREAT for my uses! I have been using 100ma 10mm leds and they work wonderfully. There bright enough to give the "effect" of strobing. One HUGE advantage is that they can be run directly off of the 595/grinch/Ren24 LV.


Reply
RPM
Posts: 1080
 RPM
(@rpm)
Noble Member
Joined: 19 years ago

Another alternative would be to use a 595 board with the ULN2803A output IC's. The ULN2803A is rated for 500ma per output at up to 50 volts.

Just my 2 cents...

Robert

awhaley wrote:The per channel rating on a grinch is 90ma.... so you can run one led at 90ma, or 3 at 30... etc, assuming you're running it off 5v... the grinch can handle up to 17volts on the output side, so you could run 5 3v leds in series at 90ma. For strobing, there's probably some 'headroom' given that you're leaving everything on for no more than .1s, but there's no way to calculate that, so all I can do is quote the 90ma off the data sheet. 🙂

Art

Edit: You ALSO could come up with a pretty simple solution to switch small (but larger than 90ma) loads from the grinch with a transistor or mosfet....


Reply
Page 3 / 3
Share: