Pixel data connecto...
 
Notifications
Clear all

Pixel data connectors - advice

1 Posts
1 Users
0 Reactions
5,472 Views
Posts: 844
Topic starter
(@ags0000)
Noble Member
Joined: 16 years ago
[#48408]

I'm attempting a build of a new pixel driver. It's a one-off custom item suitable for just one megatree. I've gone through two versions so far, and this newest will be the biggest improvement with 2x the pixels. In both previous versions I used RJ45 jacks and Cat5 cable to get the pixel data lines from the controller out to the pixel strands. That was at a much slower data rate than the new design. I've found that RJ45 is not really great for wet conditions. It is very convenient to connect 8 channels with one click though.

This new design will probably use data/ground pairs (4 channels/Cat5 cable - 4 pairs data/ground). That will take up a lot of room on the controller board (16 RJ45 jacks). It occurs to me that I really only need 5 connections for each Cat5 cable, since there are 4 data lines but only one shared ground. That led me to think about using the Euro-style connectors often used. Those are nice, but still big - and I realize that I really don't need the screw-on female connector. Once the female is mated to the Cat5, it will stay there for life (or until cut off).

I'm wondering what other PCB-cable multi-conductor connectors I should consider. I need 16 banks of 4-data,1-ground connections. I first thought that a simple 0.1" pitch header would work, but how to get the female header connected to the Cat5? Then I thought of the Molex connectors. I guess I may have to purchase a crimping tool (but I already own the crimper "jaws" that accept different crimping die sets) but that's OK with this many connections to make. Are there other suggestions, pros/cons?

Thanks.


Share: