Inline SSR
 
Notifications
Clear all

Inline SSR

49 Posts
16 Users
0 Reactions
16.6 K Views
JasonPortwood
Posts: 753
Topic starter
(@jasonportwood)
Noble Member
Joined: 17 years ago
g2ktcf wrote:Jason,

Nice start for the PCB...but I have a question.

The problem for us is the cost of the power wire...the communication cables are cheaper. It normally serves us better to put the SSR at the point of use instead of at the point of source. Does this make sense? It very well could be that you have a special circumstance but I just wanted to point out the challenges cost wise.

Thanks Chris it does make sense. kychristmas's explanation is really good on this.

I had already thought about the exposed signal/data wires but haven't come up with a solution yet that doesn't involve making it more costly or more complex. The easiest would probably be to just wrap the exposed wire in electrical tape and be done. At 27 channels it's still a lot of CAT5 but I'd have to get that up there anyway with the SSRs.

I figured this was worth a shot to draw it up and see what it would cost or if it's really worth the time. Worse would be this is too much, because of the number I want, but for something like a shooting star it may be a slick way of doing it and hiding things.

Jason


Reply
JasonPortwood
Posts: 753
Topic starter
(@jasonportwood)
Noble Member
Joined: 17 years ago
kychristmas wrote:I have one, but I thinks its in an older program. I'll see what I can find.

In your diagram, what is that top component? From Don's I have 4 parts but yours has a fifth. Is that a fuse?

Thanks!

Jason


Reply
kychristmas
Posts: 3955
(@kychristmas)
Famed Member
Joined: 18 years ago
aixelsyd wrote:In your diagram, what is that top component? From Don's I have 4 parts but yours has a fifth. Is that a fuse?

Thanks!

Jason

No, that was a Screw Terminal for the lights, but I ended up simply soldering the Icicle section directly to the SSR. That way I could put some Shrink tube around it.

I'll try to take pictures of the one I built. It looked ugly, but worked well 🙂

EditL: by the way, my fuse was inline. One fuse for 4 sections or (SSRs). I actually just used the Plug from the icicle strand I cut up. I figured the buit-in fuse was correct since I was putting less.


Reply
JasonPortwood
Posts: 753
Topic starter
(@jasonportwood)
Noble Member
Joined: 17 years ago

Thanks for the explantion of the diagram. That's a good idea on the fuse. Just put it inline on the cord.

I'm still trying to find the "quiet time" to draw up the next version of the PCB after reading all the tips. Right now my concern is getting the orders for lights done can't miss the pre-sales.

Jason


Reply
Reddy_Kilowatt
Posts: 547
(@reddy-kilowatt)
Honorable Member
Joined: 19 years ago

When I did my chasecicles, I considered doing inline ssr's similar to yours and sealing the boards in a 35mm film can. The lid could drilled out to fit thru the Cat-5 and power wire and sealed with hot glue or silicone.

667220 film canister

What I ended up doing, was using a spare Ren-24 that I had. I chained the icecicles neutral on through and ran spt-1 out from the controller to feed two segments per run.

01 15 10 0171
01 15 10 0142
01 15 10 0022

-Craig


Reply
Page 3 / 10
Share: