Finally Affortable ...
 
Notifications
Clear all

Finally Affortable Snowfall Tubes (FAST)

448 Posts
68 Users
0 Reactions
263 K Views
Posts: 231
(@jmksparks)
Reputable Member
Joined: 18 years ago

I was thinking of ressurecting an Olson and run them direct ( no ssr ) you say approx 30ma each, this should be within the capabiltys of an Olson per channel would this be correct. ?.


Reply
Posts: 1792
(@barbotte)
Noble Member
Joined: 17 years ago

all i am planning is running a pc power suply .. conected all of my tube to it let them run from dust til dawn ... as i cannot see myself trying to run a sequence to them as they will go down randomly anyway ...way easier that way ...
cheer


Reply
dlovely
Posts: 3167
(@dlovely)
Famed Member
Joined: 17 years ago
jmksparks wrote:I was thinking of ressurecting an Olson and run them direct ( no ssr ) you say approx 30ma each, this should be within the capabiltys of an Olson per channel would this be correct. ?.

I can't get the Wiki to load this morning to see if it has a per-channel recommendation, but the ULN2803 data sheet says 500mA total, so 30mA per channel with all 8 channels on is only 240mA.

Also, you have to consider if you have indicator LEDs installed, those could add another 20mA. So it would be ~50mA/channel pushing the chip close to its max.


Reply
Posts: 231
(@jmksparks)
Reputable Member
Joined: 18 years ago

My version of the Olson is the one in the file library with the indicator LEDs run of the 595s ( before the ULN2803 ) so its looking good. As for leaving them going, I think in my circumstances people would assume the ( SHOW ) is about to start. Plus I like the idea of complete radomization through programming. Sorry I cannot get the Quote,s to work this morning.


Reply
dlovely
Posts: 3167
(@dlovely)
Famed Member
Joined: 17 years ago

Someone had asked in the chat about triggering these, and the Ren48LSD has been mentioned, but if you are only looking at a few tubes the Ren4Flood will work too. I just confirmed with Brian that not installing the regulator and jumping the in/out of it will allow a 5v input/output. This would give you 4 channels, with up to 4 tubes on each channel.


Reply
Page 34 / 90
Share: