Notifications
Clear all

FGII

30 Posts
12 Users
0 Reactions
15 K Views
FireGod
Posts: 655
Topic starter
(@firegod)
Honorable Member
Joined: 19 years ago

Update: I got a little time to work on it some more. I got the RS232 serial port working. Dimming was a little strange. I tried the wireless and I found that I had the header connections for the wireless modem flipped. I got it connected but it would not communicate with the PIC chip for some reason. At this point I broke out the o-scope and things went south.

Apparently the ground on the o-scope is earthed (VAC neutral) and not floating. I went to connect my scope ground to the to the board ground and fried the 5VDC power circuit on the PIC chip side. I blew up several components and traces, an expensive lesson. I am going to get an isolation transformer for testing purposes and the next round of testing will be done with 12 VAC rather than 120 VAC.


Reply
kmc123
Posts: 824
(@kmc123)
Prominent Member
Joined: 19 years ago

That SUCKS!!!
I'm truly sorry. I'm going to look in the manual to see if mine is earthed now.


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 20 years ago

First time I read this I thought that he broke the scope...then I read it closer...

--

Phil


Reply
FireGod
Posts: 655
Topic starter
(@firegod)
Honorable Member
Joined: 19 years ago

The scope survived the board did not.


Reply
FireGod
Posts: 655
Topic starter
(@firegod)
Honorable Member
Joined: 19 years ago

It lives!

The board works and I have tested at 12VDC, 12VAC, and 120VAC. The RS-232 serial port works and the wireless serial modem works. I have not tested the RS-485 but it should work also.

I'll need to come up with a new dimming curve since the rectified voltage acts differently that the unrectified. It works perfectly on DC input but is a little weird on AC.


Reply
Page 5 / 6
Share: