Notifications
Clear all

FGII

30 Posts
12 Users
0 Reactions
15 K Views
FireGod
Posts: 655
Topic starter
(@firegod)
Honorable Member
Joined: 19 years ago

I am going to use the same PIC code as I currently use. I will treat the IGBTs as SSRs. Switching will be at 60 Hz.

I have run models on PSPICE and according to PSPICE it will work.

I have made a prototype and I have a several issues to sort out before making a second stab at it.

FGII small

Reply
mrpackethead
Posts: 2289
(@mrpackethead)
Famed Member
Joined: 19 years ago

Hey firegod, i was wondering if you coudl comment on

(a) what type of IGBT's you are using, unforutnatly it seems there is no reference on the schematic.

(b) whats kind of modulation scheme are you using? I see above its PWM. What frequency are you running this at? JEC was working on a modulation scheme that was based on some bit wise operators rather than a timing loop ( or hardware PWM based outputs ), which was pretty clever as it did'nt consume much cpu at all, ( however there are some issues to get around ).

(c) are the diodes between the pic and the igbts just for isolation of the pic from the igbt.


Reply
FireGod
Posts: 655
Topic starter
(@firegod)
Honorable Member
Joined: 19 years ago

a) SGP13N60UFTU

b) I am using the same pic code as I would a normal SSR. 50Hz or 60Hz depending on where you are on the planet. The plugin for the FGDimmer has a correcton curve for AC if you are using AC.

c) Yes, just for safety isolation from the high voltage. The PIC gets damaged at 7 VDC and it is possible to get 160 volts to the pin without the diode.


Reply
mrpackethead
Posts: 2289
(@mrpackethead)
Famed Member
Joined: 19 years ago

Thanks for the rapid reply!

So the modulation, is pretty much stock standard phase angle control.

Have you thought about turning on at the zero cross ( reverse from what you do with a triac ), and turning off at some time later.. the reason for doing this is a significant reduction in harmonics output..


Reply
Posts: 2630
(@dynamoben)
Famed Member
Joined: 19 years ago
mrpackethead wrote:
Have you thought about turning on at the zero cross ( reverse from what you do with a triac ), and turning off at some time later.. the reason for doing this is a significant reduction in harmonics output..

This method of dimming doesn't reduce harmonics. It does however lengthen lamp life and will reduce filament hum.


Reply
Page 3 / 6
Share: