Falling Icicles
 
Notifications
Clear all

Falling Icicles

7 Posts
3 Users
0 Reactions
5,093 Views
Matt_Edwards
Posts: 2664
Topic starter
(@matt-edwards)
Famed Member
Joined: 18 years ago
[#14634]

This year I have decided to add some falling Icicles.
The folllowinf are the specifications / Features I am working with:

16Ch
LED Constant Current drivers
12Volt Supply
DMX based

I envisage using 3 White LEDs per section all wrapped in 1/2'' or 3/4" clear PVC pipe tubing.

The normal PCB thickness is 1.6mm.
Has anyone had 1mm boards made up? What are the Pros and Cons?


6 Replies
ErnieHorning
Posts: 4434
(@erniehorning)
Famed Member
Joined: 19 years ago

I've used .0315 inch which is .8 mm that I CNC milled. I used it for surface mount parts and I saw no issues. This is the same thickness as memory cards are for PC's.

I also tried .01 inch (.254 mm) for an SOIC to SO wide adapter. This worked too but you have to be quick with the solder because it warps easy from the heat.


Reply
Matt_Edwards
Posts: 2664
Topic starter
(@matt-edwards)
Famed Member
Joined: 18 years ago
ErnieHorning wrote:...... but you have to be quick with the solder because it warps easy from the heat.

Ernie,
Thank you. I seem to remember that from my production days. I think I will just stay with 1.6mm.


Reply
Matt_Edwards
Posts: 2664
Topic starter
(@matt-edwards)
Famed Member
Joined: 18 years ago

I should have these controllers in this week. Once I build and test some, I will post Gerbers and Code for others.

If the spacing between the LEDs is 10 mm and I allow an additional 25mm between the section, this brings the total length to 720mm for the LEDs and an additional 200mm for the controller housing or 920mm.
Alternatively I could used 10mm and 35mm spacings to give a total length of 1080mm.

Has any one made falling icicles? I am trying to get a feeling for the overall look and feel of them. My only experience as been some small 300mm units that came insets of 5 and ran asynchronously to each other. My design will be 3x longer.


Reply
Matt_Edwards
Posts: 2664
Topic starter
(@matt-edwards)
Famed Member
Joined: 18 years ago

Was able to build the first Prototype last night. Darn it I found 1 error on the PCB. The Regulator has the wrong footprint. I wanted to use a SOT-223 device. Also I am waiting for the SMD Caps to arrive. Other than that, the firmware flash in OK and the Diag LEDs operate as expected.


Reply
Page 1 / 2
Share: