Centralised Ehterne...
 
Notifications
Clear all

Centralised Ehternet or DMX?

7 Posts
4 Users
0 Reactions
2,557 Views
Matt_Edwards
Posts: 2664
Topic starter
(@matt-edwards)
Famed Member
Joined: 18 years ago
[#20283]

Of late I have been thinking of small pixel display items that use about a universe of channels. Ordinarily I would opt for DMX to Pixel bridge.
Is it time to go straight to an E1.31 Pixel bridge? the cost isn't expected to be too disimilar to a DMX Pixel bridge providing I include isolation.
Any thoughts?


6 Replies
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

To clarify - do you mean an E1.31 Pixel bridge for a single universe? The only issue is that the Ethernet bit is proportionally the most expensive part and it seems a bit overkill for a single universe of pixels. You're running a single cable anyway - why not stick with an E1.31/DMX bridge to a DMX-Pixel bridge - with focus on the DMX-Pixel portion you could probably make this fairly cheap.


Reply
Matt_Edwards
Posts: 2664
Topic starter
(@matt-edwards)
Famed Member
Joined: 18 years ago

Yes.
At $10 for a w5100 chip and rj45 inc magnetics the cost is not that much higher than isolate DMX port.

I already have DMX to pixel bridges.

Sent from my GT-I9100 using Tapatalk 2


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

OK - wasn't aware you were looking at the chip level (vs the module) - in that case then yeah, it would be a nice project.


Reply
Posts: 604
(@aussiephil)
Honorable Member
Joined: 19 years ago

Matt

It's what the J1Sys ECG-P2 is in many ways though it does have 2 ports and can handle 8 universes, but it is designed as a point of use type unit.

I think that as more new people pick up pixels from scratch then pure E1.31 may well be logical but even then for smaller items that use say up to 20-25 pixels the DMX pixel controllers still make logical sense.

It's still a case of picking the right controller that fit's the requirements of the installation.

Cheers


Reply
Page 1 / 2
Share: